Electronics Forum | Thu May 20 10:54:31 EDT 2004 | Cal
Hello All- I am in need of some low cost solutions for conveyors. SMEMA Conpatible about 3" (1meter) in length. Single stage is fine....I will even consider good used one...Free would be even better!!!. I have checked the archives and came up empty.
Electronics Forum | Fri May 05 03:38:02 EDT 2023 | ttheis
I am looking for some parts to repair a dyna-pace 1 meter conveyor if anyone has a scrap unit laying around. We just need the sheet metal edge strip as shown in the attached photo. Also looking for width adjust handles and a source for the 10mm wide
Electronics Forum | Sun Feb 05 17:01:31 EST 2006 | GS
total footprint should be about 4 square meter Let's consider dimensions: - length (conveyor) = 1,58 mt - width (front+back)= 2,50 mt Regars.......GS
Electronics Forum | Thu Jul 07 01:26:34 EDT 2016 | lukvel
I have not tested whether there is electrostatic discharge on the PCB or not because the electrostatic meter is still on its way. But the IPC-A-610 section 3.1.2 specifies that yes even compressed air nozzles that move air over insulating surfaces g
Electronics Forum | Mon Apr 02 10:32:46 EDT 2018 | dleeper
Any half meter conveyor should work for you. Any SMT equipment broker should be able to help you fine one too. Shouldn't cost more than a few thousand dollars (US) tops. Check with the seller of the package you are considering, I'd be surprised if h
Electronics Forum | Mon Feb 09 10:19:27 EST 2009 | tomg_fla
I am looking for a semi-manual system that an operator can use on a 2 meter conveyor to assist in part placement onto printed boards. We do some prototype assemblies where we don't get parts tape and reeled. Am looking at something that can pick up a
Electronics Forum | Mon Feb 09 12:27:41 EST 2009 | markhoch
I too am interested if anyone has any assistance that they can provide. A few years ago I took a table top, manual pick and place system and had a "table" machined that would allow me to bolt it onto one of our two meter, Inspection Station, conveyor
Electronics Forum | Wed Feb 12 17:10:02 EST 2003 | Mike G
Most conveyors are sold by the inch. I allow for no more than one inch gap between the end of the conveyor and the next piece of equipment. If you trust your measurements, 1/2 inch is best. This will allow for the smoothest transfer possible of small
Electronics Forum | Wed Apr 19 14:16:28 EDT 2017 | dekhead
As a tech, much happier when there are conveyors between machines (although 1/2 mtr seems sufficient)... in house maintenance much happier when it's a conveyor to move rather than the printer.
Electronics Forum | Fri Feb 28 10:32:45 EST 2003 | pjc
Cookson Electronics Equipment- Electrovert AquaStorm 200 highly recommended options: Checkmate Conveyor Hurricane Jets in Wash and Rinse 4 Additional Top Spray Bars in Wash *Closed Loop Filtration System for Wash *Positive Displacement Chemical Meter
.gif)
