Electronics Forum | Thu Nov 24 01:21:42 EST 2022 | crystalw4280
The bottom piece of the sensor broke, and it threw it off, fixed now. Wasn't sure, it must have come loose enough to throw it off, but not enough to trigger an error that it wasn't working...because it was still in the casing
Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Electronics Forum | Tue Oct 24 19:09:12 EDT 2023 | sarason
Possibly blocked air lines did you check air pressure? Also drivers on the relevant boards. or simply damage in the flexible wiring harness( a nightmare) sarason
Electronics Forum | Fri Sep 18 13:59:05 EDT 2009 | cyber_wolf
Can anyone tell me the difference between these two machines ?
Electronics Forum | Tue Aug 23 15:27:38 EDT 2005 | Frank
I know this post is getting a bit old, but the Juki KE-2060 can do 0201 up to 74mm square (or up to 150mm long connectors) on their standard machine. You only need to purchase the 0201 nozzle and feeder. The machine is factory set to run 0201. And
Electronics Forum | Thu Jan 25 13:06:11 EST 2007 | james
I am looking for any comments as far as the JUKI 2050 or 2060 placement reliability? Does anyone have experience with these machines and could give me their input? Thanks
Electronics Forum | Tue May 02 23:34:26 EDT 2006 | Frank
The 2060RE model that I have can do an 18"x20" board. I think the Mydata can do larger. Juki did tell me that next year they will release a machine that will do larger boards but didn't specify on how big. The 2060RE can do 0201 up to 74mm square
Electronics Forum | Fri Jan 26 06:59:38 EST 2007 | james
Have you had any placement problems due to pickups being off?
Electronics Forum | Sat May 24 04:45:20 EDT 2014 | mpolak
Check if that component is not skipped in component data.