PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/topic3114&OB=DESC.html
. Is there a way to get the text with correct size when converted into OrCAD? I guess there is somewhere a mapping parameter where I could not find it in FP designer
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/ref-des-text-size-is-not-ok-in-orcad_topic3114.html
:40pm Hi, I use OrCAD 17.4. In the FP designer, I made a footprint where I have the silkscreen refdes height=1.27mm, and the assembly refdes height=0.5mm
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/ref-des-text-size-is-not-ok-in-orcad_topic3114.html
:40pm Hi, I use OrCAD 17.4. In the FP designer, I made a footprint where I have the silkscreen refdes height=1.27mm, and the assembly refdes height=0.5mm
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic3114&OB=DESC.html
. Is there a way to get the text with correct size when converted into OrCAD? I guess there is somewhere a mapping parameter where I could not find it in FP designer
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic3114&OB=ASC.html
:40pm Hi, I use OrCAD 17.4. In the FP designer, I made a footprint where I have the silkscreen refdes height=1.27mm, and the assembly refdes height=0.5mm
GPD Global | https://www.gpd-global.com/pdf/doc/CMOS-Setup-Procedure-for-2025-0064-22100114-6-v18.pdf
. If item B is absent, then a parallel port is not present and you need to change the parallel port parameter in SuperIO Device (pg 12). – If a parallel port is present, leave Onboard Parallel Port set to
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/CMOS-Setup-Procedure-for-2025-0064-22100114-6-v18.pdf
. If item B is absent, then a parallel port is not present and you need to change the parallel port parameter in SuperIO Device (pg 12). – If a parallel port is present, leave Onboard Parallel Port set to
GPD Global | https://www.gpd-global.com/pdf/doc/CMOS-Setup-Procedure-for-2025-0121-22240103.pdf
... ...compare them to values illustrated under each topic in the Screens Appendix (pg 6). 10/21/20 CMOS Setup Procedure 2 GPD Global© Set Non-Default Parameters For the CPU board to operate properly, several parameters need to be set to a non-default value. HINT
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/CMOS-Setup-Procedure-for-2025-0121-22240103.pdf
... ...compare them to values illustrated under each topic in the Screens Appendix (pg 6). 10/21/20 CMOS Setup Procedure 2 GPD Global© Set Non-Default Parameters For the CPU board to operate properly, several parameters need to be set to a non-default value. HINT
GPD Global | https://www.gpd-global.com/pdf/lead-former/CF8-Calibration-Setup-and-Alignment-Kit-821-1-115M.pdf
. If it does not, use fine grit sandpaper to smooth out the inner edge. 6. Place all six (6) screws in and hand tighten. 7. Using the customer’s shaft and GPD timing tool, place the hub on the shaft, line up a notch on the wheel shim with the point of the timing tool
