Electronics Forum | Tue Dec 19 01:57:52 EST 2006 | hemu_me
we have fuji's cp-iv-3 machine made in 1993.we are facing problem everytime when we change the jobs(for example we change from pcbA to pcbB to pcbA)even though program is same. There are some mechanical adjustments like conveyor adjusted according to
Electronics Forum | Fri Jul 23 12:52:35 EDT 2004 | Micheal
I would take a good look at Juki's 2000-series machines. We have a few and they are very easy to learn. Setup is minimized with offline setup. Adjust conveyor width and you are ready to run. Juki has provided good support and the machines require
Electronics Forum | Sat Apr 14 10:21:30 EDT 2007 | HOSS
We are processing a 5x22" PCB using Juki "2010E and 2060E". Machines are spec'd as 18x20" cabable. We just needed to adjust a conveyor sensor (1 time) and ignore a few placement area warnings.
Electronics Forum | Thu Apr 07 10:36:45 EDT 2011 | markhoch
It's all relative to your Zone Temps and the thermal profile of your assembly. Without knowing what they are, we'd be irresponsible to offer any advice on adjusting your conveyor speed.
Electronics Forum | Tue Dec 19 16:15:47 EST 2006 | johnw
we have fuji's cp-iv-3 machine made in 1993.we > are facing problem everytime when we change the > jobs(for example we change from pcbA to pcbB to > pcbA)even though program is same. There are some > mechanical adjustments like conveyor adjusted
Electronics Forum | Wed Jun 16 10:02:58 EDT 2021 | shmevan91
Yes this has been checked, had to change them to manual in order to manually adjust the rail width by hand by turning the chain.
Electronics Forum | Tue Nov 21 20:21:11 EST 2006 | billwestiet
Most machines for lead free have adjustable conveyor angles (4 to 8 degrees). In the good ole days with lead, we typically ran at about 6 degrees. Often we see closer to 4 degrees with lead free. This is very common, and provides longer immersion
Electronics Forum | Wed Jun 16 08:16:27 EDT 2021 | shmevan91
Hi, Could anyone shed some light why a mk5 13 zone heller ovens rail width won't auto adjust? has to be done by hand every time we change product. The board support rail will adjust just not the main rail, have tried swapping the two cards around bu
Electronics Forum | Wed Feb 17 14:17:36 EST 2010 | davef
Is your oven adjusted correctly for temperature and blower and conveyor speed?
Electronics Forum | Wed Jun 16 08:55:08 EDT 2021 | bukas
have you checked how is oven configured in oven setup wizard? if you run it now you should be able to see current config. make sure you backup old config before making any changes.
