Electronics Forum | Fri Aug 10 02:30:46 EDT 2001 | praveen
Hello Friends, Please advise how critical is the Micro BGA baking? The BGA size is around 7x7mm and we need to program it before mounting. The Micro BGA's are supplied in Trays and are put in to tape and reel after programming.We need to put these BG
Electronics Forum | Tue Feb 18 16:31:43 EST 2003 | arturoflores
Haran: Have you made improvements regarding your BGA shorts? We are facing the same problem and we think it is partly because the non coplanarity of the seating plane of the BGA which causes BGA balls to squeeze on one side of the BGA. Also, we ha
Electronics Forum | Thu May 15 07:37:49 EDT 2003 | pteerink
Have seen similar circumstances a couple times. Possible causes: 1) PCB defect - remove the BGA and inspect/test the PCB for shorts. ( trace short, layer short etc ) 2) PCB defect that only shows up when the BGA is populated - a short somewhere o
Electronics Forum | Thu Jul 31 15:29:25 EDT 2003 | bcceng
A couple of things you can look into 1. The proper bottom pre-heat of board. If you are applying only direct hot air to BGA without preheating can cause BGA's to warp and collapse un-even. 2. Moisture on you BGA's. If BGA's were not properly packa
Electronics Forum | Mon Sep 29 02:35:28 EDT 2003 | Sam
Hi Mantis. Has there been any changes in the BGA itself? One of our BGAs changed to a newer type, and after that we had problems with corner lifting. In that case problem was BGA's structure, there was mismatch in TCE between BGA's substrate and mo
Electronics Forum | Tue Dec 06 15:52:39 EST 2005 | pjc
There are quite a lot out there now: http://www.sapltd.co.uk/electronic_production/bga_scope/bga_scope.htm http://www.ocwhite.com/bga/ http://www.hirox-usa.com/bga.html http://www.jergensinc.com/infodir/catalog_asg.asp?GroupNum=175 http://www.sm
Electronics Forum | Tue Sep 19 16:59:41 EDT 2006 | davef
BGA inspection microscope * sapltd.co.uk/electronic_production/bga_scope/bga_scope.htm * ocwhite.com/bga/ * hirox-usa.com/bga.html * jergensinc.com/infodir/catalog_asg.asp?GroupNum=175 * smttools.com/bga100.html * huntron.com/products/optilia/optili
Electronics Forum | Mon Aug 11 10:45:04 EDT 2008 | eyalg
I assume you mean the balls of the BGA, not pads > (laugh it up guys - I said balls). If so, you > may have a no-lead BGA or a high temp BGA. hi I mean that the the balls were left on the board and the BGA pads were found clean. What do you
Electronics Forum | Thu Feb 25 10:54:03 EST 2010 | duanebrayton
We are a small Contract Manufacturer and have received a project which has BGA's on top & bottom. 2 larger BGA's on one side (~_20x20mm) & 3 smaller BGA's (~_8x8mm) on the other. we plan on running the side with the smaller BGA's first but need som
Electronics Forum | Wed Aug 18 16:26:21 EDT 1999 | Tony
Yesterday as I was creating a profile on a plastic BGA using Conceptronics freedom 2000 rework station, I happend to discover that I was able to remove solder bridging from a plastic BGA. This is what I did. Created a removal profile, I had a board