Electronics Forum | Thu Feb 06 14:01:55 EST 2014 | rgduval
1. Fuse 2. Power Supply 3. Power Distribution card 4. Booster Start by checking all of the fuses on the front of the power supply (accessed by removing the front cover of the machine). Then, check all of the fuses on the first card in the MOT bay.
Electronics Forum | Tue Apr 21 12:48:13 EDT 2009 | bk
ok you verified that the motor was bad. So now i would go back and verify that your voltages are still good on the back of the computer box and on the booster board. If they all check out fine. I would take the mot x board from your working machine a
Electronics Forum | Fri Mar 11 09:42:50 EST 2005 | cyber_wolf
If you are not getting repeatable transducer readings then some possiblities are : 1. Transducer is bad 2. Motor is bad 3. Y power booster Also, I can't remember if the Y motor has a flex coupling on it or not. If it does, check that out. Also, w
Electronics Forum | Wed Jun 27 12:19:34 EDT 2012 | allgood
We concur - we reduced problems by lowering the booster panel to the horizontal and putting two pedestal fans behind the machine blowing onto it - but I think once the ambient air has heated up the cooling effect is reduced of course - we have a smal
Electronics Forum | Mon May 13 11:05:49 EDT 2013 | shankar2013
I have moved the MOT cards. The messages are still the same. Booster +25V is stable, The BM3 +25V indicator shows no +25V which means any of the feeds down the chain pulled it down. So basically once it is low the relays in the BM3 card will not latc
Electronics Forum | Mon Jun 28 17:17:23 EDT 2021 | SMTA-64387687
The 2 big ribbon cables, on top of the X wagon. They run from the booster board, in the back, to the board on top of the X-wagon. They wear out and need to be replaced, periodically. Since, the tool cycle works, the Z-motion is probably working ok. I
Electronics Forum | Fri Oct 05 12:37:56 EDT 2007 | allgood
I think there you have your answer! As far as I know, they had some problems getting it to work and withdrew it from the market for a while but they are talking again about it. Great idea, fabulously expensive and way beyond our budgets........ In
Electronics Forum | Wed Jun 20 12:16:59 EDT 2012 | allgood
Hi John Yes I am still having the same problems years later! It keeps Fred in work supplying me with replacement tips too! Mydata came up with a supposed fix to alter a parameter called prepick which puts a pause in I think allowing the head to st
Electronics Forum | Fri Jan 10 11:32:52 EST 2014 | rgduval
Hi, Hans, I would have suggested swapping the MOT card out to see if that fixes the issue (or, changing the MOT card with another one to isolate the card), but, it sounds like you've already done that. I'm surprised that MyData would point you towa
Electronics Forum | Fri Sep 02 11:44:59 EDT 2005 | Brian
We (ETS) are a manufacturer of reflow, curing and preheat systems and have had similar requests from customers in the past. One in particular required soldering onto an aluminum heat sink weighing approx 5 lbs. You might consider selective/robotic so
