Electronics Forum | Thu Jun 09 18:59:49 EDT 2016 | spoiltforchoice
You'd have more luck looking at where it is located in the circuit than posting a picture a of brown brick with contacts either end. Its fairly chunky so sure it could be a ferrite of some kind (but they are normally black) or indeed a Fuse, self re
Electronics Forum | Fri Jun 14 12:13:40 EDT 2002 | cyber_wolf
Pete, Holy crap 320C peak !!! What the heck are you soldering ?Is the residue charred, or brown ? I am familiar with TACFLUX009, is tack flux 007 NO-clean ? Need more info.....
Electronics Forum | Thu Dec 09 15:40:59 EST 2004 | russ
You may want to talk to Bruce Brown at wavetech soldering services. bbrownwave@aol.com 949-489-9250 714-904-7662
Electronics Forum | Fri Sep 02 08:58:35 EDT 2005 | Rob
We used to see that a lot with securicor before DHL bought them. They used to tape up the boxes again with brown tape & pretend nothing had happened. We even had tire marks on one box.
Electronics Forum | Thu Nov 30 14:16:50 EST 2006 | realchunks
Cooking bags. The ones for "large bird game" work very well. I believ I got them from Hormel. They are not ESD approved, but your thermal recorder should come out dry and well browned.
Electronics Forum | Thu Feb 15 12:45:44 EST 2007 | chrisgriffin
If you think you are having lighting issues, you should do a histogram test. It's under the test user. There is a pot on a power supply that will adjust the brightness. The power supply is right next to the Y axis motor. There should be a brown p
Electronics Forum | Thu Feb 22 05:30:06 EST 2007 | lococost
nothing but... We've had peel-off melting after reflow, burn up and turn hard and brown, melt in the holes and then turn hard... All very hard to remove afterwards. We have yet to find a proper solution.
Electronics Forum | Fri Mar 27 18:19:28 EDT 2009 | blnorman
We use paper labels with a protective coating to prevent browning during reflow. We've had no problems coating over these labels with our silicone. If your coating is not silicone, a Sharpie should print on the coating.
Electronics Forum | Fri Sep 05 13:49:04 EDT 2008 | gregoryyork
Tell the board shop to increase the cure temp of the resist as it is undecured especially if you have waxy/greasy resiues on the board and a brown tar like substence in the solder wave itself. If undercured then solder will not flow off the resist pr
Electronics Forum | Fri Aug 29 10:18:31 EDT 2008 | rrpowers
We saw this one time when we were trying to develop some lead-free product. It ended up being copper migration. Some of the pads had a brown discoloration and those that did would not wet very well. Your elemental analysis would have shown if ther