Electronics Forum | Thu Jan 07 03:32:19 EST 2021 | ravikumargv
Dear All, In S27HM siplace machine PCB camera images not display and when i try to teach feeder potion or fiducial position PCB camera light is glowing but, images not showing in monitor, kindly help what is the root cause for this issues... Regard
Electronics Forum | Sun Nov 10 05:40:27 EST 2019 | compit
It turned out that only SF heads support "fine" mode, while FNC does not. Probably because above the FNC nozzle there is a "circle" rotating the nozzles, and in fine mode it can interfere with the reflection of the camera light - the element is lower
Electronics Forum | Wed Apr 17 18:27:16 EDT 2024 | acouto
Yes, it is the same type, the problem only happened after the technician removed the mark camera and the light. The manual states that you should not move the mark camera light with your hands. So I think I may have miscalibrated the equipment in som
Electronics Forum | Fri Apr 24 13:55:09 EDT 2015 | duchoang
- Clean nozzles. - Clean camera. - Adjust lighting. - Check tolerance level. Good luck.
Electronics Forum | Sun Mar 25 15:17:38 EDT 2012 | duchoang
I used Topaz x and X2 long time ago. I might be wrong, but let's check the thickness of components and the camera light recognizing setup for each part. (?). They may be too different to be optimized for simultaneously pick-up and place.
Electronics Forum | Tue Sep 16 13:34:26 EDT 2014 | gascon5383
we are checking two fiducials on this product, as for most products. its always the first fiducial it checks where the camera light flashes and wont take a picture.
Electronics Forum | Tue Feb 27 12:43:43 EST 2001 | gsmguru
I've used an on-axis camera lighting for other components with a good deal of success. (But not for CGA's in particular) I would think it should work pretty well for a CGA application. I've done some pretty odd looking parts with this type of lightin
Electronics Forum | Wed Nov 17 03:58:18 EST 1999 | Bach Huss
Hi we are running S-15 here and the LED for the component camera is not all bringht at the same brightness level. This cause us to use different .gf for our standard component. It is hard to ballance the illumination level between machines. Does a
Electronics Forum | Fri Sep 20 05:17:10 EDT 2002 | byates
What are the error codes?? you dont even know if it is the vision type until you have checked this out. It could be camera lighting. Do you know how to use vision trace on your machine? What is your x&y tolerance? What about vision 254 or 255 have yo
Electronics Forum | Thu Jan 13 17:45:24 EST 2005 | vickt
Clark, As a start....Do you have a qualified tech on site to verify that the camera lighting is within spec? If not it's hard to say where you are starting from. I know that UIC still has trained personel that can help you out on this older gear if y