Electronics Forum | Wed Nov 24 06:38:57 EST 1999 | carl
Hi Larry; Have you tried just to place it as a square. Or if all fails try vision 254 255. Just be carefull with this as it will place nothing if the reel runs out. Give me a call.
Electronics Forum | Tue Nov 30 14:47:34 EST 1999 | EmJay
Larry, TRy using #254 and front light the part. When you define the leads leave plenty of tolerance and use a P-Pattern of 34.
Electronics Forum | Sat Jul 26 12:37:10 EDT 2014 | jimmyboz
In the future, please try to explain the situation with some detail. Usually this is the sensor on the 10th station to verify to nozzles are in the up position.
Electronics Forum | Tue Nov 17 13:07:54 EST 2015 | cyber_wolf
Nothing in that machine is very valuable. We totally scrapped 3 of them. Not sure on the software but I would guess that it's not something you could not sell due to software licensing BS.
Electronics Forum | Wed Nov 18 10:40:40 EST 2015 | sarason
Send me a copy. You can find my address at http://members.iinet.net.au/~sarason/ regards sarason
Electronics Forum | Mon May 21 20:55:19 EDT 2001 | dougk
We have both CP 4/2's and 4/3. We're also running Siemens S20's & F4's. The 4/3's vision is more temperamental and slightly harder to program. Machine startup and nozzle centering takes longer, but placement time is slightly better. Honestly, for wha
Electronics Forum | Tue Apr 24 12:34:44 EDT 2001 | 061032
Hello all, Has anyone out in SMT land have any feed back on the Fuji Cp743 placement machine. We have older CP4-2 machines and they have held up pretty well...but we jumped on the Siemens band wagon 18 months ago and whamo...we have had more servic
Electronics Forum | Tue Dec 07 22:05:19 EST 1999 | sin
Added to MARK suggestion, you should verify you xy table height also by using the meter listed in the maintenace manual. If everything is fine, then i suggest you should check the placement air kisses( can suck your component back up or release to q
Electronics Forum | Wed Nov 24 07:02:15 EST 1999 | JAX
Larry, Carl's right about vision 254 and 255 but I believe CP4's can be set up to check for a part on the nozzle,(parts check sensor)like any other CP. This could be activated to make sure parts are being placed. Then again CP4's might not ha
Electronics Forum | Thu Oct 28 20:14:28 EDT 1999 | xujun
hi,sai: we have a same m/c that is cp-43,but we haven't encounter the problem about servo board.I think is ac- speed- adjustment servo board.if you can conform th board is bad,consulting the fuji service agent is the best way! best regards
winsouce.jpg)
