Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Tue Feb 16 08:47:38 EST 2010 | jdengler
We powered up our CP-IV today and got an error. About 7 seconds after power on page 000 comes up with nothing in any of the areas except for second status area which contains "LD INIT" in yellow. After about 16 seconds the second display area gets
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Mon Jun 21 13:16:18 EDT 2021 | tomdegas
I just received the following messages while running our MY15: I-OSM-0: my15n150 kernel: lp: no devices found. I also received this one: I-OSM-0: my15n150 insmod: /lib/modules/2.2.20/misc/lp.o: init_module: Device or resource busy. And this one: I-
Electronics Forum | Tue Feb 11 15:31:10 EST 2020 | sumote
We have not used out tray handler in several years, and when I had a need arise the thing now throws a Servo Error "MTU1 ALARM [11081010]. There are 4 servo packs in the cabinet. When I try to initialize/zero out the machine the 2nd and 4th servo pa
Electronics Forum | Wed Jan 29 18:41:22 EST 2014 | alphatronique
Hi did you look for mechanical issue like friction somewhere ? when init i use very low force buy much more while running that may explain wly machine work in production fur fail only on init i face that whit flex cable that make just little fr
Electronics Forum | Mon Apr 18 18:23:41 EDT 2022 | youngbuck
Hello everyone, We have a Siemens HS50 error going on as soon as we boot up. It shows message saying "Machine is in test mode." Cause: Initalizing gantry axes. Start Sitest and check machine (firmwre versions,configuration, etc. It will try to refere
Electronics Forum | Mon Jun 19 10:10:18 EDT 2006 | rmitchell
Hi, Our CP6-5 has a Z overflow error when trying to zero set. The table moves in X and Y and almost zeros prior to the Z overflow. Servo Amp? Rob
Electronics Forum | Fri Jul 13 07:00:31 EDT 2018 | negev
I am not sure if anyone can find this information usful...but I will post it anway, our old CP-642 couldnt start up with "LOADER INIT ERROR"changing the battery in the CP1 I/O card solved the problem.
Electronics Forum | Thu Aug 05 20:37:22 EDT 2004 | Haran
Pls advise how the part thickness affects the placement for Chip Shooter like CP6.