Electronics Forum | Wed Mar 20 15:25:05 EST 2002 | angiewest
Looking for a company to recycle plastic reel and I.C. tubes. I already recycle trays with Smart Cycle (formally Semicyle). I hate to throw that stuff away. The local recycling places only recycle plastic 1 and 2. Most of the reels are 3's.
Electronics Forum | Fri Jan 16 07:48:29 EST 2004 | Mika
We usually program the components in the component database with pin 1 in the lower left corner. Then in the feeder database we set the component orientaion to 270 deg for Tray feeders(turn the tray in the feeder 180 deg) and "tube" feeders. For tape
Electronics Forum | Thu May 25 18:58:49 EDT 2000 | Mukesh Lad
We are a tape and reel house,we use a variety of machines. If you are looking for low voulume, low cost and easy set up for you operators. I would look at Systemation MT-30, this is a good work-horse, I have used them for 10years for small runs, no
Electronics Forum | Thu Dec 10 22:36:03 EST 2020 | solderingpro
I represent PROMATION USA and we have several solutions for solder wire perforation: Our QUICK 372B is a stand-alone drilling station. Our QUICK 371DI is a semi-automatic hand soldering station with perforation technology. Our QUICK 300A/B is a d
Electronics Forum | Fri Dec 13 11:29:30 EST 2002 | R.G. Albada Jelgersma
I am looking for a facility to fulfil my needs in tape and reeling (re-reeling and from tubes to reel), anti-static and humidity packing etc. in the EU, preferably Holland / The Netherlands / Belgium. In my search I am a bit stuck. Could you help me
Electronics Forum | Fri Apr 22 10:12:14 EDT 2005 | davef
Common RTV does out-gas causing corrosion. NASA allows use of non/low-out-gassing RTV. Try the following companies: * Ablestik Electronic: Materials, 20021 Susana Road, Rancho Dominguez, California 90221 U.S.A., 310-764.4600, F 310-764-2545 * Arlon
Electronics Forum | Tue Sep 18 05:22:34 EDT 2012 | sarason
Try this page for the updated machine An FP-100 about 85 psi. for this model. The basic machines are near identical , just newer plastic moldings. I think I ran mine off a car inner tube and a 12V tyre pump, originally. So that would have been a
Electronics Forum | Sat Apr 20 10:12:16 EDT 2002 | davef
If people use an inert gas, they use nitrogen for mass soldering. Inert gases get progressively more expensive as you move down the periodic table. Many times no-clean flux is less active than other flux types. So, people use an inert gas to lower
Electronics Forum | Wed Feb 01 13:46:05 EST 2006 | Chunks
Sounds like a epididymis! It depends on your paste chemistry. You can't just slap any old saponifier in there. Most water based cleaners evaporate the water and you have to remove the dried paste. It's a bit messy, maybe that's why your's is over
Electronics Forum | Thu Jul 18 17:38:27 EDT 2019 | rgduval
Not swapping out feeders....swapping out magazines. It only works well if you have enough extra mags to load all the feeders on. And is a viable solution if your position limited on your machine. Before the advent of Aegis feeders for My machine