Electronics Forum | Mon May 26 04:39:49 EDT 2014 | sarason
Damn near impossible. You need to see a real change in the difference between the 2 elements you are reading. So to give yourself any hope run 2 long traces one top one bottom up the length of the board. Then compare to 2 wriggly traces at one end (o
Electronics Forum | Mon Jul 23 09:43:50 EDT 2007 | pjc
From NASA document: Conformal coating thickness shall be determined using a wet film thickness gauge,....... Wet Thickness Gauges can be obtained: Wet film Thickness Gauge P/N 790010 Nordson Corp, Amherst, OH or http://www.nordson.com/cgi-bin/MsmG
Electronics Forum | Sat Jun 29 18:59:43 EDT 2019 | davef
You weren't clear on the type of gauge that you're using. Strain gauge load cells are the most common. These load cells have two gauges. The orientation of the gauges affects cell performance characteristics. * Temperature compensated: Temperature
Electronics Forum | Fri May 29 18:40:40 EDT 2015 | bigdaddysoy9
Hello, Do you use No Go gauges at AOI? If so, how often? Every changeover, etc.?
Electronics Forum | Thu Nov 20 08:41:12 EST 2008 | grics
Good morning SMTNET FORUM!!! Its been a while since I have been on. Good to see people are out there still helping other people. I have a question... What is everyone using for Coating Dry Film thickness verification? We are using micrometers. My
Electronics Forum | Tue Jul 25 20:32:00 EDT 2000 | Dave F
Thanks John. You�re correct. I�ve seen tables like that. poorly stated, what I was wondering was: * Is there a calculation that relates the gauge and the inner diameter ... OR * Is that relationship similar to wire gauge and wire diameter. I th
Electronics Forum | Thu Mar 18 07:58:43 EDT 2010 | mun4o
It is a pressurized system, and , Yes , there are a message "No flow nozzle 1".Our machine have not 'ShoRate' gauge at the back of the machine.There are only 3 gauge for flow on the front side , like watch ???
Electronics Forum | Tue Mar 23 09:47:45 EST 1999 | Dan Hughes
George, No it does not make sense to measure the tension on a mounted foil, however, if you wish to please your customer you might want to find a tension gauge that measures in mils of deflection. In the beginning, screen tensions were all measured
Electronics Forum | Wed Feb 17 17:21:10 EST 1999 | Kiet D
I'm qualifying Ablebond 8360 from Ablestik for hybird circuit assembly. Anyone has experience with this epoxy. In my preliminary experiment with this epoxy, I had a seperation problem with a 30 gauge needle which we are using for dispensing 84-1LMIS.
Electronics Forum | Wed Jul 19 20:56:53 EDT 2000 | Dave F
hey, what the relationship between needle gauge and inside diameter
