Electronics Forum | Thu Jun 25 12:11:03 EDT 2015 | island2013
Let us know how it goes. We offer Mydata support and parts should you need it. http://www.islandsmt.com
Electronics Forum | Sat May 04 14:36:53 EDT 2013 | dontfeedphils
It's been a while since I've used a MyData but I believe what happens is on the bottom of the hydra black metal piece is a mark that the vision system uses to locate the tools as they pass over to center the parts. Something may have happened to this
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Mon May 06 14:55:58 EDT 2013 | dyoungquist
We had that problem on our M12. There were a few components that had gotten dropped into the camera area as the hydra head past over it. Our MY12 has a knob towards the front of the machine in direct line with the camera. Pulling this knob release
Electronics Forum | Mon May 06 19:21:39 EDT 2013 | amelby
We had that problem on our M12. There were a few > components that had gotten dropped into the > camera area as the hydra head past over it. Our > MY12 has a knob towards the front of the machine > in direct line with the camera. Pulling this
Electronics Forum | Wed May 13 15:57:43 EDT 2020 | azdback
We have been working on an intermittent error on our hydra. And it seems to happen only after several hours of production have passed, it doesn't happen during the first part of the shift. Our hydra goes from working fine for several hrs to making
Electronics Forum | Sat Oct 03 07:26:01 EDT 2009 | cflames17
Check the reference plate on the hydra to make sure it is not cracked or delaminated. I have had problems with the glue coming loose and the plate flapping causing this same problem. check hydra camera calibrations, this to may help.