Electronics Forum | Fri Oct 04 12:02:53 EDT 2002 | mzaboogie
Hi Barry, One consideration that you may want to consider is the lead to hole ratio. The higher the ratio, the less solder is required to fill in the gaps and give you a fillet. Heat is a concern. You will need to ensure components will take the he
Electronics Forum | Mon Aug 18 10:42:04 EDT 2008 | floydf
We are in the process of preparing for a new board that requires paste in hole processing. The hole is a .020" via, and our customer wants it filled with solder, but not bulging past flush. For printers,we use a DEK 249 with a squeegee, and a DEK 260
Electronics Forum | Fri Jun 25 03:16:38 EDT 1999 | Scott Davies
Wayne, Earl, I wish there was some way we could toss our wave solder machine forever! Unfortunately, we haven't found a way yet to do paste-in-hole reflow for large numbers of thru-hole axial and radial components, which we insert on Universal machi
Electronics Forum | Mon Aug 18 11:20:08 EDT 2008 | pjc
Stencil apertures are cut to deposit solderpaste onto the annular ring, provided its wide enough. Then you can place a solder preform if needed to ensure there is enough solder to fill the barrel. Here is some information on solder preforms: http://
Electronics Forum | Mon Jun 28 11:47:54 EDT 1999 | Christopher Cross
| | | hello, | | | | | | has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. | | | thanks for the input | | | | | | wayne | | | | | | | | | | | We have tried this mainly
Electronics Forum | Thu Sep 04 10:24:39 EDT 2003 | paulrm
The typical PIP process is incorporated into the surface mount process. This approach requires the following: The stencil will be designed so that the correct amount of solder paste can be printed onto the through-holes to form an acceptable joint
Electronics Forum | Thu May 20 07:53:55 EDT 1999 | Chris Nuttall
| | We care currently running into problems during our plug via process: | | At the moment we plug prior to soldermask (LPISM) using epoxy resin - plugging takes place from the component side - however we are seeing solderballs after solder level.Thi
Electronics Forum | Tue Jan 30 01:32:24 EST 2001 | PeteC
Bill, We do solderpaste reflow on through-hole here every day on plated-thru-holes. We do it on connectors only. It is a reliable process. We use no special profile. The stencil apertures must be modified for this process. Check out the IPC-7525 "St
Electronics Forum | Mon Nov 26 09:33:49 EST 2018 | charliedci
The problem you create by soldering from solder destination side (presuming you have already soldered from other side) is that you will trap air in PTH so you have virtually no continuous solder in PTH from one side to other. This will not meet IPC-A
Electronics Forum | Thu Oct 30 23:39:10 EDT 2014 | beilimanu
No paper thing, while I can make some suggestions based on my experience. what is the size of your via? If it's smaller than dia0.4mm, in PCB production process it should be filled by soldermask. So my suggestion is design it to be full filled by SM
