Electronics Forum | Thu Aug 31 19:40:22 EDT 2006 | cardinal
A couple things on the Grid-Lok system. They now offer a top-side edge clamping system. The edge clamping system works very well for warped, twisted boards etc.. Using this system in the auto mode also allows the pins to contour to the geography of
Electronics Forum | Wed Nov 20 16:27:15 EST 2002 | pjc
FYI: MPM does in fact offer alternate board support tooling than the vacuum box system. They have the X and Y snugger tooling, which clamps the board and uses magnetic support pins. If you are looking at a used UP2000, check to see what tooling it ha
Electronics Forum | Tue Mar 28 19:34:50 EST 2006 | daxman
Hey Sr.Tech .. Thanks for you help with my CP6 problems by the way.. Did you just get this machine? We've had many initial problems with ours. Most of them were related to the air pressure settings. There should be 2 regulators on the back of the
Electronics Forum | Fri Apr 21 00:56:44 EDT 2006 | pavel_murtishev
Good morning, MPM AP25 we have is equipped with dedicated vacuum support only, no side snuggers. Also we had a lot of issues with fine pitch paste deposition due to this poor support. Vacuum support can�t fix wrapped boards properly causing a lot of
Electronics Forum | Wed Aug 30 08:06:45 EDT 2006 | scombs
The reason I asked earlier about Gridlok is that we are using the on 2 Dek Horizon printers (since Jan 06) with edge clamps and they work well. We run them in Auto mode so they conform to the board at each print so I do not have to worry about the op
Electronics Forum | Wed Aug 30 10:42:42 EDT 2006 | chrisgriffin
I would recommend the UP2000 HiE. This would more than handle what you have describe. If you have a lot of warped boards, the side clamp retro might be for you. I haven't had much production experience with the grid lock, but I know of several pe
Electronics Forum | Wed Apr 26 06:51:11 EDT 2023 | poly
I'm looking to make dedicated tooling for my mpm stencil printer. We only make 3 different boards and they are the same size panel so I'm planning to make one bit of tooling for them. One board is 0.6 mm and sometimes I have problems with it not bein
Electronics Forum | Wed Oct 14 08:27:26 EDT 1998 | Earl Moon
| | | | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will i
Electronics Forum | Wed Oct 14 15:33:48 EDT 1998 | Justin Medernach
| | | | | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will
Electronics Forum | Tue Sep 29 01:51:37 EDT 1998 | Earl Moon
| I'm going to purchase a screen printer. | I've looked at the SMTech/Sigma 500 (also called Quad AVX500). | Has anyone any comments to this machine or production experience? | Anything would be appreciated. | I'ld like to hear any other type of ma