Electronics Forum | Wed May 25 19:04:39 EDT 2005 | russ
check your clamping rails and see if you see any little wear marks, we constantly hit these clamps during placement when the parts are too close to the edge. The height of that clamp is either 4 or 6mm I beleive and the noozles will hit them on occ
Electronics Forum | Wed May 25 19:47:01 EDT 2005 | russ
It wouldn't be that many placements (billions) since we are a low volume high mix shop but we have placed 100s of thousands with the N08 for sure. We use the N045 by far the most since we seem to be an 0603 and smaller type shop (probably into the m
Electronics Forum | Mon May 16 12:39:48 EDT 2005 | JB
Agreed with the previous posts: *Make sure there is one empty nozzle changer per head. *Make sure there are no components on the nozzle changers that prvent the nozzle from seating flush with the changer. *make sure all nozzles are fully seated. *Ch
Electronics Forum | Fri May 13 18:10:35 EDT 2005 | pde
Make sure all plugs and nozzles occupy the nozzle banks. There should be only one empty position. Make sure all nozzles are fully seated and the machine has the correct location for all of the nozzles. An indication may be the machine is trying to pl
Electronics Forum | Mon Jul 26 17:54:41 EDT 2004 | Jeff
Sounds to me like a nozzle changer issue; broken garages or needs to be calibrated?
Electronics Forum | Thu Jul 19 12:47:16 EDT 2012 | timeproducts
Looking for nozzles for a multitronics LVX
Electronics Forum | Thu May 19 08:28:08 EDT 2005 | geb
Thanks for everyones help. I have resolved this by filling all but one of the nozzle holders in nozzle changer banks.
Electronics Forum | Mon May 16 11:45:35 EDT 2005 | PWH
Agree with PDE. We have two GSM's and we get this error often. Palm down e-stop when you get this error message. Machine will drop nozzle bank down after doing some segment repairs. Open covers and make sure nozzles are seated in reference to ali
Electronics Forum | Thu Jul 22 05:43:56 EDT 2004 | jbtech
Can some one explain to me why the ceramic nozzles are cracking not on the tip but on the base??? also how long do the sleeves last, no informaton from siemens they just came in and changed from 'o'ring to bearing type?? Thanks Julie
Electronics Forum | Fri May 13 11:00:19 EDT 2005 | geb
I have a Universal GSM which won't change nozzles from the changer. It says something along the lines of "timed out waiting for air pressure to build". Even though it has around 100PSI air pressure. Any ideas how to solve this? Cheers
We offer various kinds of high quality SMT nozzles, feeders, cutters, filters, etc. Sales1@kundasmt.com
Equipment Dealer / Broker / Auctions
Room 208 haochen building #286 dongping Industry Zone
Suzhou, 04 China
Phone: 0086-512-68364089