Electronics Forum | Tue Apr 15 11:48:14 EDT 2014 | proy
Interesting idea the sprite sugar/water mix.... I found a spray on BBQ cleaner which worked pretty well, but is a little sharp on the lungs! Peter
Electronics Forum | Thu May 01 06:42:25 EDT 2014 | cbeneat
I use Simple Green, works pretty well, although I use the concentrate and don't dilute it as is recommended, so it's pretty strong. I am going to try the sugar water though. I'm intrigued.
Electronics Forum | Thu May 01 18:21:26 EDT 2014 | hegemon
Of course now I am really wondering if my own guts like the Sprite/Solvent... 'hege
Electronics Forum | Mon Apr 14 15:37:00 EDT 2014 | jdenuzzia
If you do a search on Reflow Oven Cleaning Fluid, you will find links to companies and chemicals that can assist you. I recommend that you contact one or more of the companies and discuss your needs and the paste you are using. They should be able t
Electronics Forum | Mon Apr 14 20:13:40 EDT 2014 | davef
So, someone is going to get a chance to buy a nice and shiny oven, eh? Summary from my notes of old thread on SMTnet: Some people melt sugar and use that solution to clean cooked-on flux residue. Dissolve sugar into warm water, spray it on the area t
Electronics Forum | Tue Sep 02 14:59:41 EDT 2008 | hermes
if two boards with different solder masks give different results on flux residue level after soldering with the exact same machine settings than it is clear that one of the solder masks is not compatible with your no-clean flux. could be the solder m
Electronics Forum | Thu Aug 28 11:31:17 EDT 2008 | patrickbruneel
Matt solder mask finishes gives the widest process window in view of potential amount of residues when using No-Clean. Shiny (glass like) finishes are more sensitive to residues due to lower surface area compared to matt finish. If the shiny finish i
Electronics Forum | Thu Aug 28 09:30:20 EDT 2008 | patrickbruneel
Omid, No-clean fluxes need to be used right out of the can without thinning. In the past with RA and RMA fluxes you could adjust or thin them to your desired density because they had plenty of solids up to 30%. No-Clean fluxes have a lot lower solid
Electronics Forum | Wed Aug 27 14:58:21 EDT 2008 | omid_juve
we have problem in setting the density of a no clean flux for using before wave soldering . first we dilute the flux but we have many short circuit problem between the pads of edge connector,then we densify the flux all the short circuit is removed b
Electronics Forum | Wed Feb 26 22:22:00 EST 2003 | Grant Petty
Hi, The guys here have some boards that have been reworked however as we use no-clean paste we are getting the white residue after ultrasonic cleaning. We are using an alcohol based cleaner in the ultra sonic cleaner. Does anyone have any ideas, or
