Electronics Forum | Wed Aug 27 12:15:15 EDT 2014 | jimmyboz
I understand what you want, I do not however, understand why? I have checked some documentation and found nothing. If I know why, I might try harder for a solution. It doesn't seem like time is crucial, else you want to pre-pick. Two easy ways ar
Electronics Forum | Thu May 12 00:18:55 EDT 2016 | darby
Sorry for delay - been flat out. Sr - I understand what you are saying. My concern is that combined with the head offsets and variations in pick points (i.e. having to teach feeder positions for very slight amounts like 0.05mm)then you cycle times wi
Electronics Forum | Wed Aug 27 12:38:48 EDT 2014 | fuji_user_2014
We do a lot of low volume prototypes and several boards that have have cut outs or fixtures that dont always reliably stop squarely at the in carrier (beveled corners). This sometimes results in a fid read error, because the fid wont be in the search
Electronics Forum | Fri May 06 07:58:33 EDT 2016 | cyber_wolf
Darby, I'm not completely sure I understand. Juki machines have what is referred to as a multi-head. The offsets between the heads are the same as the spacing between 8mm feeders. So the (6) heads all come down at once and "gang pick" from 6 8mm fee
Electronics Forum | Wed Sep 24 15:08:13 EDT 2003 | davef
Try: * Excelta Roto-Pic� 2000A [www.excelta.com] * Porta-Wand or Vac-Pac [www.virtual-ii.com] * PELCO� Vacuum Pick-Up System [www.tedpella.com]
Electronics Forum | Mon May 08 19:27:27 EDT 2006 | Tech
Does anyone know if you can teach feeder pick up location on 24mm. I have a 1998 Philips Topaz. Thanks
Electronics Forum | Wed Sep 24 13:22:37 EDT 2003 | Pete C
Try these out www.egismos.com/newproducts.htm
Electronics Forum | Thu Sep 25 09:37:48 EDT 2003 | Pete C
Dave, Don't know, just found it on the web. Most suppliers will send one for trial.