Electronics Forum | Mon Mar 21 21:38:40 EST 2005 | pmd
You do not need to back up segrep. This is only used for boards currently on the machine whenever the machine encounters a palm down or soft stop. It only contains what is mounted and or not mounted on that board. No System infomation is contained in
Electronics Forum | Mon Mar 21 21:28:41 EST 2005 | pmd
I agree with dave. Two things prevent oders from drains. The "P" trap and the celing or roof vent. If the system is sealed from the pump on then it should run thru a "P" trap this prevents vapors from comeing back thru the pipe. To make sure suction
Electronics Forum | Mon Mar 21 23:05:19 EST 2005 | pmd
Software driven RS-232 interface. machines must have compatable software.
Electronics Forum | Tue Mar 22 20:32:54 EST 2005 | pmd
IMX, NEMI, CMAX. http://www.nemi.org search for IMX. http://www.eislab.gatech.edu/pubs/conferences/1999-mt99-scholand/
Electronics Forum | Tue Mar 22 20:48:29 EST 2005 | pmd
sorry about mistake on last reply try this one and search their site for XML http://www.nemi.org search for XML.
Electronics Forum | Wed Mar 23 20:44:25 EST 2005 | pmd
Sounds like EA has way too much free time on his hands. How are you taking a reading. What instruments are you useing to get a reading. What are you looking for? Voids? Adhearsion? Contamination? Why would you need to know what it takes to break a co
Electronics Forum | Thu Mar 24 22:39:22 EST 2005 | pmd
My opertaors have lots of setup problems with vib feeders. They dont realize that the chip weight pushes parts down and when feeders run low it's the frequency that drives the parts. Mixing parts with diferant phisical deminsions and masses in the sa
Electronics Forum | Mon Feb 21 10:29:32 EST 2005 | OverTheHill
O. Tarango = Troll Paul pmd = O. Tarango
Electronics Forum | Sun Mar 20 19:26:02 EST 2005 | devilhitam
Thanks pmd for input. The main concern here, was there any standard document regarding this coplanarity check were implemented?
Electronics Forum | Mon Apr 02 17:25:53 EDT 2012 | tombstonesmt
Just PM'd our Pillarhouse Jade Mark II this morning and found excessive solder balls all over the solder pot as well as the bottom of the machine. While removing all the dross it's very obvious that the dross is a REAL fine powder unlike any of the o