Electronics Forum | Thu Apr 14 05:23:10 EDT 2005 | dj_jago
What is the pitch of the device and what type of flux are you using? You may eridicate the fault by using a more active flux. I assume you are flowsoldering the device as opposed to paste in hole. Do you have an air knife? If so, you could tr
Electronics Forum | Tue Mar 19 07:24:17 EDT 2024 | aglucky
Common Reasons and Solutions for a Non-Functioning Ice Maker As one of the most frequently used and common household appliances. Our ice maker can provide refreshing food, drinks, and fast and stable service. However, in our daily lives, ice makers m
Electronics Forum | Thu Apr 14 14:29:37 EDT 2005 | shagnasty
MPM Help!? On start up when my machine is comping up to the start screen i'm getting a air pressure fault please help. Email @ hillardb@protekelec.com or call me direct @ (941) 915-5134 Thanks Brian
Electronics Forum | Wed Aug 27 23:12:37 EDT 2008 | amt61114
Our Cencorp TR1000 PCB router is down with a fault on the KaVo Type 4444 converter that reads "888.8" on the LED display. None of the documentation we have can explain what this fault means. We're searching for a replacement converter but have foun
Electronics Forum | Wed Apr 13 21:04:39 EDT 2005 | pdeuel
We have a controlled pressure facility. When the pressure is set at 0.2 lbs above outside our security doors that open outward do not close by themselvs causing alarms. Our facility remains dusty under and on equipment because of conditions listed on
Electronics Forum | Fri Apr 13 10:13:30 EDT 2007 | Bob R.
We had a crisis with one BGA causing huge yield losses due to this defect. Nothing we could do with the profile got rid of it. Changing paste didn't get rid of it. It was the BGA warping in reflow, caused the corners to lift up when the solder was
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Tue Dec 23 15:06:25 EST 2008 | evtimov
It depends how manual is the printer. you need to control pressure and speed. If you control both by hand, it is difficult to discuss results. If the pressure is controlled by the printer, than you should be able to do it by one deposit. Also is the
Electronics Forum | Sun May 26 02:06:39 EDT 2019 | jlawson
Placement force can cause chip cracking-micro cracks also. As machines are getting faster they tend to not control force other than spring pressures and z displacements. There are some machines that have full closed loop place pressure control , but
Electronics Forum | Thu Aug 17 19:29:54 EDT 2006 | foxhound
Im having problems with my ap 25. I get the air pressure fault alarm when it boots up so I bypassed the air pressure switch but I still get the alarm. The air routes through the machine as soon as I hit the on button, I thought it wasnt suppose to
