Surface Mount Technology Association (SMTA) | https://www.smta.org/icsr/speaker_forms/Paper-Format-Requirements.doc
. It is also helpful to understand any constraints that may exist. Some constraints at Dell’s EMs include the fact that nitrogen reflow was not widely available and no-clean solder flux was required
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/07/last-will-of-bga-void.pdf
°C Temperature Range [7] Kim’s investigation utilized two different reflow profiles – typical (aka LSLP) and non-typical (aka Extreme) – to generate voids in the BGA solder joints
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2022/04/last-will-of-bga-void-1.pdf
°C Temperature Range [7] Kim’s investigation utilized two different reflow profiles – typical (aka LSLP) and non-typical (aka Extreme) – to generate voids in the BGA solder joints
Surface Mount Technology Association (SMTA) | https://www.smta.org/knowledge/journal.cfm
: Whisker Inspection Results André M. Delhaise, Stephan Meschter, Polina Snugovsky, Jeff Kennedy, Zohreh Bagheri Abstract 32-2 Warpage of Flexible-Board Assemblies with BGAs During Reflow and Post-Assembly Usage Pradeep Lall, Kartik
Surface Mount Technology Association (SMTA) | https://www.smta.org/education/presentations/presentations.cfm
court-approved Expert Witness in civil litigation matters concerning post-reflow cleanliness assessment and contamination-related failure mechanisms. Mike is the founder of Aqueous Technologies, a manufacturer of automated cleaning and cleanliness testing
Surface Mount Technology Association (SMTA) | https://www.smta.org/webinars/
process automated if volumes require. Through hole paste reflow can benefit using solder bricks to increase joint volume and decrease flux residues. Some placement machine suppliers offer produced cut and form feeders, so solder wire is used, reducing the
Blackfox Training Institute, LLC | https://www.blackfox.com/about/instructors/
. He has the unique ability to see the “Big Picture” from start to finish in all aspects of electronics manufacturing and find ways to increase efficiency while constantly improving quality and reducing cost
Surface Mount Technology Association (SMTA) | https://www.smta.org/news/smta_calendar/calendar.cfm
. Through hole paste reflow can benefit using solder bricks to increase joint volume and decrease flux residues. Some placement machine suppliers offer produced cut and form feeders, so solder wire is used, reducing the cost of simple preforms Back in the day the presenter used preforms with vapour phase and
