Electronics Forum | Thu Oct 22 14:37:27 EDT 2020 | kumarb
Hi. Did a similar update to our Emerald-X (YV88X) and the USB Floppy Drive emulator works like a champ! Installed within a few minutes with 100% success. Way more elegant than 1.44M floppies. Can you share more details on the FD Emulator you have so
Electronics Forum | Thu Mar 17 09:56:34 EST 2005 | jmedernach
Tx, Your spec limit is the point at which you expect to see a failure. In other words, what is the probability that you'll see a short when you have .008" of solder paste? What is the probability that you'll see an open if you have .004" of solder
Electronics Forum | Mon Jan 08 19:52:14 EST 2007 | fastek
A soft limit error is an error due to trying to drive the head outside it's mechanical limits. Check your X-axis program data for this part.
Electronics Forum | Mon Oct 17 13:02:28 EDT 2016 | tdemon69
i have a MPM2000 now giving me 0 - hardware limit warnings..let me start off by saying that is was giving me x axis limit problems, so i replaced the x card with diff card. set all the switch and jumpers to x card , then i got 0- hardware . so then
Electronics Forum | Mon Jan 29 08:18:48 EST 2007 | mika
Hi Sami, A little more detailed information would be good,as it perhaps makes it easier for us to point you in the right direction of the root cause of your problem. And then you should fix that, rather than tweaking your programs around. 1. What typ
Electronics Forum | Mon Dec 26 12:21:15 EST 2005 | davef
Sure, you can use X7R dielectric ceramic capacitors on mixed technology boards. You need to be aware of the limitations and design and control your process appropriately. Continuing: * BIG cracks show as hard failures * Small cracks show as a leakag
Electronics Forum | Sat Oct 06 15:00:42 EDT 2012 | chrisnims
We bought a used 1999 topaz x and are trying to get it up and running. unfortunately we are getting an error: Anyone know where i can get a service manual or having any idea where to look to resolve this problem? "E229" “Nozzle down limit sensor is
Electronics Forum | Sat Sep 22 01:30:31 EDT 2007 | mika
I am sorry my friend, but I can't recall that specific error number. But it would help if you explain a little bit more about your problem. Remember that an error code Do Not necessary points to a direct root-cause of a problem. First of all we nee
Electronics Forum | Mon Sep 10 17:52:30 EDT 2001 | mparker
Are you doing actual measurements of the dummy parts placements? or are you just doing a visual go/no go check? If doing actual measurements, be sure to use mil inch units of measure rather than mm. Mil will give you more accurate readings. mm force
Electronics Forum | Fri Sep 24 13:44:06 EDT 1999 | Eric Lee Williams
| | The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table