Electronics Forum | Fri Apr 20 11:05:23 EDT 2001 | gcs
Just a bullet! My results are, .005" stencil thickness should measure between .0055" - .006" if your pressure is correct, metal blades and snap-off is set up correctly. Do you have aperture reductions at the QFP locations "typicial industry standard
Electronics Forum | Fri Apr 20 15:27:00 EDT 2001 | jimlew
We do some aperture reductions - but it's not the 10% i'm accustomed to. Looks like it should be more than we currently do (I think we do 10% of length, but no width). Don't think we have a slumping problem, and we're not doing snap-off, only contact
Electronics Forum | Fri Apr 20 08:41:56 EDT 2001 | jimlew
For those of you out there, like myself who are still using 2-d to measure paste ht, I have 2 questions. 1. Typically, what tolerance are you applying to your ht? +- 1 mil, or what? 2. Are you using metal squeegees, and if so, have you found that squ
Electronics Forum | Tue Dec 11 19:48:37 EST 2007 | arun2382
Hi, If I were working with a 75 um thick stencil, Is there a spec. as to what the maximum value allowed on actual solder height measurements? Stencil type: Laser cut and electropolished Solder paste type: Type 4 Sn-Sb Would the measured values va
Electronics Forum | Tue Feb 21 21:17:41 EST 2006 | Cal Kolokoy
M, The paste height is what you establish it as. You're probably using a laser measurement system, and these depend on where your reference datum is. Some will measure from a silkscreen, a trace, or solder mask. These add height, not to mention H
Electronics Forum | Sat Apr 25 19:40:01 EDT 1998 | Stan Traxler
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components We have appl
Electronics Forum | Wed Sep 07 03:03:35 EDT 2005 | Milroy
I am engaged with SMT production and we are going to have a brand new SMT line and I am studing about the screen printing and I have seen most commonly used stencil thickness is 6mil and I need to know what is the best solder paste height we can achi
Electronics Forum | Fri May 21 15:50:41 EDT 1999 | John Thorup
We are running a number of boards with 8-10 25 mil PQFPs on board. Our process is mature with at least 3 years experiance and statistically few opens on the QFPs. Our beloved purchasing department has chased the almighty $ and changed FAB vendors
Electronics Forum | Mon May 24 13:33:46 EDT 1999 | Dave F
| We are running a number of boards with 8-10 25 mil PQFPs on board. Our process is mature with at least 3 years experiance and statistically few opens on the QFPs. Our beloved purchasing department has chased the almighty $ and changed FAB vendor
Electronics Forum | Sun May 23 15:12:59 EDT 1999 | JohnW
| We are running a number of boards with 8-10 25 mil PQFPs on board. Our process is mature with at least 3 years experiance and statistically few opens on the QFPs. Our beloved purchasing department has chased the almighty $ and changed FAB vendor
