Electronics Forum | Mon Jun 21 14:55:27 EDT 1999 | JohnW
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Thu Jun 17 20:35:51 EDT 1999 | Earl Moon
| | | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | | | for example: | | | | | | Solder Bridge | | | 1.verify amount of flux been aplied. | | | 2.verify turbulance on
Electronics Forum | Thu Jun 17 15:18:54 EDT 1999 | Earl Moon
| Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | for example: | | Solder Bridge | 1.verify amount of flux been aplied. | 2.verify turbulance on your solder wave. | 3.etc.
Electronics Forum | Thu Jun 17 19:52:57 EDT 1999 | Tony
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Wed Feb 19 19:46:29 EST 2003 | adlsmt
I estimate the costs about the same but we build in batches so the wave only runs a few hours a day. We do complex boards so I think its worth it plus you have to keep the machine awhile to recoup the investment in the new nozzles. If the market gets
Electronics Forum | Thu Sep 14 11:56:47 EDT 2006 | russ
I think you have your pitch wrong but anyway, I have never had success with wave soldering anything less than 50 mil pitch. On a QFP I have had good luck on three sides of 25 mil but never all four sides and without defects. Mask 'em off and hand s
Electronics Forum | Tue Apr 16 15:01:55 EDT 2002 | wf
Have you considered point-to-point selective soldering using microflame ? If we look at the excellent points that Dave made.... The clearance required for the microflame is minimal, no tooling plate is required - only to fixture the parts and the p
Electronics Forum | Fri Jan 21 15:23:41 EST 2005 | Steve C.
Thanks for the help. It was just the wrong mix. Ie: No thinner. Need to check them more often. Cheers
Electronics Forum | Fri Jan 21 11:15:28 EST 2005 | russ
Are you running any type of vibratory wave on the Vitronics as opposed to the electrovert? How about any turbulent wave differences if any? The only time I have ever flooded boards in fixtures is when the seal is broken or run an excess amount of v
Electronics Forum | Wed Dec 10 05:06:20 EST 2008 | gregoryyork
Great as most Lead Free machines have the wrong angle on them 7 degrees is correct. So you are still exiting the wave in the middle of the pot then.
