Electronics Forum | Wed Jun 11 15:57:39 EDT 2003 | pjc
Frank, ECD (WaveRIDER) and Datapaq (Optimiser) have wave solder machine process control devices. They will check the following: 1. Conveyor speed 2. Preheat Temps 3. Solder Temps 4. Wave Dwell/Contact Times 5. Wave Heights 6. Waves Parallelism Go
Electronics Forum | Fri Jun 28 13:49:31 EDT 2013 | proceng1
Hi, > > I was just hired on and put in charge of > the wave machines. One lead and one no lead (lead > free). My company currently does not have a wave > profiler. He wants me to jury rig the re-flow > profiler to work on the wave. I really thin
Electronics Forum | Fri Aug 28 06:39:29 EDT 2009 | sachu_70
I had seen such effect caused by the wave itself, where the exposed wave surface was coated by a thin dull oxide layer which then adhered to the bottom side of PCB during wave soldering. You could verify if the wave surface is clean metal when the P
Electronics Forum | Fri Nov 03 09:59:46 EST 2000 | Mark Krmpotich
Has anybody done an evaluation on Wave Solder Process Control Modules? I am looking at the ECD WaveRIDER or the Wave Solder Optimizer to try and implement process control on our wave soldering operations. Which is better for controlling the process
Electronics Forum | Tue Aug 05 17:38:48 EDT 2003 | D
Try to mechanically force the solder up the holes if it is equipped with a Smartwave. The Smartwave tries to provide additional wave action like the Electrovert Omega wave. Try more time in the wave. How did the old wave machine perform on these boar
Electronics Forum | Mon May 07 11:25:21 EDT 2007 | colormaker
Flux foam is not affected by board or pallot. This wave is not the same as the hollis I used. The hollis wave flowed from middle to left and right side. This wave only flows to the left and its a very slow wave. Jerry
Electronics Forum | Thu Jun 07 09:14:48 EDT 2007 | hussman
Chip waves are supposed to be turbulant. You have 2 waves, correct? And you're talking about the first wave the board sees, right? What part is not soldering? SOT-23? Yes you should turn your nitro off when not running the wave.
Electronics Forum | Tue May 05 13:02:44 EDT 1998 | John
Does anyone have info on the rotary chip wave(compare/contrast to z wave.....)?
Electronics Forum | Fri May 07 16:58:26 EDT 2004 | davef
Manage the speed of the board and the speed of the wave to be nearly same at the point where the leads leave the wave.
Electronics Forum | Wed Aug 04 15:11:56 EDT 2004 | davef
Are these solder balls on the wave side or the non-wave side?