Electronics Forum | Wed Aug 12 14:59:01 EDT 2015 | jagpcbassy
I am looking for a saved program for the CR Technology RTI 6500. i recently had to swap out the harddrive and i lost all my saved programs and the machine does not want to come up. I can get the offline version of the software to load but nothing hap
Electronics Forum | Thu Aug 13 14:52:42 EDT 2015 | deanott
We just encountered a problem with the vision on our MPM Accuflex. We just switched jobs and when we went through a 'Vision Set-up' there was no image (just blank gray screen where you'd normally see the PCB or bottom of stencil). When we tried to
Electronics Forum | Mon Aug 17 23:29:37 EDT 2015 | aemery
DeanO, Glad you found your issue. Depending on which Speedline FSE installed your Accuflex originally, a copy of the manuals might have been copied on to the desktop or possibly in a Windows explorer folder. The operations manuals, IPB and schemat
Electronics Forum | Fri Aug 14 07:52:03 EDT 2015 | mun4o
Hi all, 2 weeks ago we installing a new P&P machine - chip shooter.But , after installation proved that vibration of the new P&P arе very strong.If I use mashine to 100% of the speed the machine vibrating and after 2-3 panels moving 3-5 mm.The machin
Electronics Forum | Wed Aug 19 09:14:26 EDT 2015 | sarason
Try a more intelligent telnet program that has a few diagnostics. I dont know the Mirae machine myself but the ext thing would be to do a trace on machine operation. maybe the booting sequence has the Telnet Host( Or is it Client?) boot after the mac
Electronics Forum | Wed Aug 19 09:05:03 EDT 2015 | scotceltic
Does anyone have a solution as follows: A scanner placed at the enterance of the screen printer, and a program created that can read a PCB's Barcode label. Send that barcode's program information to each piece of equipment (Paste Inspection and place
Electronics Forum | Tue Aug 25 07:48:41 EDT 2015 | derrikf
Both pictures are from .031" FR4. According to my MOLE it's actually staying above the liquidus temperature for close to too long. Datasheet says 90 secs, I'm in the high 80's. Not ruling it out as a possible cause, I suppose the data I'm getting c
Electronics Forum | Fri Oct 02 09:22:24 EDT 2015 | derrikf
The following is representative of on-board temps of a FR4 at .069" thickness. The thermal couples were soldered directly to the board using high-temp solder. Again, the halogen-free solder requires an identical profile to our old solder. We had grea
Electronics Forum | Wed Oct 28 06:43:13 EDT 2015 | derrikf
That's my main concern, the patchy/splotchy appearance doesn't look as pretty, especially under a microscope. When it was mentioned that my oven may be too hot in the ramp-to-faux-soak it was the first thing I tried adjusting. As far as our blade pre
Electronics Forum | Thu Aug 27 09:18:57 EDT 2015 | fcmtechnician
Hi Don't know your reflow brand, but try to decrease the blower speed...is possible that air blow out the componets! For vibration, chain related issue, etc open your hood and start the oven in colder recipe with pcb inside! ( put the service key o