Electronics Forum | Thu Mar 20 11:30:58 EDT 2014 | dave222
Hello Again. I little more information about the issue: when trying to zero machine head the spindles move up and down about 6 times before giving the error code. also I notice that all the LEDs on the circuit board are off. L11 - L18. and the nume
Electronics Forum | Mon Apr 27 11:29:06 EDT 2015 | chris_jayconsystems_com
When I do the adjust to make sure the vision and tolerance is working it works perfectly. But if the machine runs a board I am riddled with this. I have checked the vacuum levels on all the heads and they are within where they are supposed to be for
Electronics Forum | Mon Nov 09 10:19:17 EST 2020 | gregdavill
I've picked up a Yamaha YM66S II machine, On powerup it displays the following: "ERROR CODE-RAM DATA!" "INSERT SYSTEM DISK" The machine looks in good condition, and I'm reasonably confident the RAM error is just a depleted primary battery on the co
Electronics Forum | Wed Dec 02 10:00:17 EST 2020 | spoiltforchoice
That STOP error code does google. It would suggest an incomplete or corrupted windows installation. if safe mode doesn't work its very unlikely normal mode is. Sadly fixing XP issues is much harder than it is these days with Win10 which has repair fu
Electronics Forum | Thu Mar 14 15:26:34 EDT 2024 | gregoryyork
Hi After a little help we are based in England and have a Dage XD6500 Xray which has thrown up a really strange fault which our normal Dage service guy cant find. It says tube error and the error code is a 56 Volts fault from the Tube and cannot star
Electronics Forum | Mon Jun 05 22:40:40 EDT 2000 | Dean
...well, if I had Fuji in on 4 occasions and the problem is not resolved I would wonder what exactly I paid for... Here is what I would do. 1. Run the glass plate program. This will eliminate variables in your production parts and boards. Additi
Electronics Forum | Tue Aug 22 18:32:42 EDT 2006 | daxman
Thanks for your posts fellas. The machine is still down. I have tried flushing the machine, re-sending the proper and status, and booting without a program. Still no luck. I did receive an OS error, the code pointed to the CPU card. So I replaced i
Electronics Forum | Fri Sep 05 13:00:40 EDT 2003 | cabjerk
Hi: How simple or complex do you want? We run PFS software, but for our Feeder Maint we used access and just wrote a simple pgm and tied it into our PFS. What PFS gives us is how often the feeder is change out and this is used to base a feeder PM
Electronics Forum | Wed May 02 12:22:30 EDT 2007 | SWAG
Make sure you get a good upward looking camera combo. 4.0 on rear and 2.6 for PTF (platform tray feeder) parts is my favorite. Easy to wrench on, calibrate (if you have a cal. kit), and easy to program. Single beam will run at 2000+ cph and dual b
Electronics Forum | Sat Jul 07 11:45:26 EDT 2012 | btipcb
I purchased and am setting up a used QSA30. It has been a little frustrating but I finally have an almost program. The isse is that I can not generate a placement program because it says that the ANC is not registered. I can look at it on the sy
