Electronics Forum | Mon Feb 01 10:07:37 EST 2010 | davef
My Groups: * Electronic/Electrical Manufacturing * Electronics Manufacturing * Electronics Manufacturing and Supply Chain * EMS Insider (Electronics Manufacturing Services) * SMTnet.com * Surface Mount Technology Association (SMTA) * Official
Electronics Forum | Tue Jun 01 15:06:40 EDT 2010 | thanh
I did. Nothing change. I can go in mount feed back and increase .5mm for all rotations(Lazer mount feed back), then it work. But all my parts go to camera will be off the oposite way.
Electronics Forum | Sun Jul 25 01:05:49 EDT 2010 | smellew
Hi He is good & geniune supplier we buy many parts from him Regards Llew SME Llew@SurfaceMountEngineering.com www.SurfaceMountEngineering.com
Electronics Forum | Wed Aug 11 14:45:46 EDT 2010 | davef
Yes, it OK to mount axial PTH component as radial PTH, if that's what you're asking. * There are no rules for orientation. Pick something and stick to it. We like to be able to read the component value / orientation from the top towards the board.
Electronics Forum | Wed Dec 07 11:12:17 EST 2011 | thanh
go to Components Info. F4 to Pick & Mount Info scrool down to Mount Action change to Normal instead of Fine.
Electronics Forum | Tue Nov 20 13:15:53 EST 2012 | jdengler
In Texas Instruments AN-1364 they say "The TO-247 package is not recommended for surface mounting".
Electronics Forum | Wed Oct 08 11:18:41 EDT 2014 | wavemasterlarry
If its like my wave, the t-couple might not be mounted over a whole where the hot air blow out./ mounting it on the hot plate makes it over heat alot.
Electronics Forum | Sun Nov 24 22:09:13 EST 2019 | fadzril
Does anyone have experience of mounting MID ( molded interconnect device )? What items are required to be prepared? Can I use my current printer, mounter or reflow ovens?
Electronics Forum | Thu Feb 20 07:48:16 EST 2020 | benreben
Hello, The oven profil is not the solution! The only solution for the solder mount on the side is to put gel flux on the side of qfn and make a second travel in reflow . The flux remove oxyde from the copper that is not tinned and the solder is able
Electronics Forum | Wed Sep 02 17:29:51 EDT 1998 | Dave F
| How would you mount a surface mount chip onto Perf board? I am doing a project for school and one of the chips is a surface mount, but everything else fits in Perf board. Any suggestions? Thanks Matt: Here's one way to do it: 1 Get a hot glue
