Electronics Forum | Sun Feb 03 09:36:29 EST 2019 | bobpan
Good job.... Sorry i didnt see this post...some of us were busy snow tubing over the weekend...haha. Many times over the years....the rubber belt inside the feeder will deposit material inside. Sometimes it ends up on the sensors and blocks the ligh
Electronics Forum | Fri Aug 02 12:03:16 EDT 2019 | dfl
UPDATE: I was reading around about similar problems. My function #30 always return nozzle height 1. I tried to clean up the glasses and the internal laser lenses, no go, still at height 1. Even after removing both glasses, still at height 1. I saw s
Electronics Forum | Sun Aug 04 08:47:12 EDT 2019 | dfl
Hey bob, I had no luck. Even removing both glasses, cleaning that curved lenses with a cotton swab and isopropanol and blowing compressed air, the height still on 1. I will try on the next weekend again, to be sure, but my first guess is the QA un
Electronics Forum | Fri May 21 15:45:29 EDT 2010 | pforister
iv40, Thanks. The PCB that we are populating the BGA hybrid onto does not have holes in the vias. I think the manufacturer indicated that on their hybrid it has holes in pads. This hybrid is a PCB assembly with BGAs and other components populated
Electronics Forum | Wed Jan 30 15:08:10 EST 2019 | dfl
MM, exchange the cards doesn't make any difference. The problem happens when the machine is moving from left to right. Right to left works all the time. bobpan, thanks, I completely missed this one. The default was 0 and now is set to 1. The build c
Electronics Forum | Wed Nov 11 23:01:10 EST 1998 | Jason
| The only announcement that I have seen affects the line of printers (SMTech was purchased by Quad several years ago). | | is it true that Quad Systems has been acquired by Speedline? Can anyone confirm or deny this? | | | | SMTech was purchased
Electronics Forum | Fri Aug 02 08:12:55 EDT 2019 | dfl
Hey guys, I'm using my Quad IV-c for a while now and I already manage to run some batches, but I never used the "Quad Align" feature before, since almost all my boards are 1206 parts, that doesn´t need a ton of precision to align. Anyway,
Electronics Forum | Mon Jan 10 17:12:53 EST 2011 | gosswald
I have been researching older lower cost used Pick and Place machines and so far I am leaning towards the Quad IV C. There seems to be a fair amount of these units around and I have heard some pretty good things about them on some of the past posts.
Electronics Forum | Tue Jan 11 13:28:14 EST 2011 | jmw
0603 and up should be no problem on the machine. If you are doing under 25 mil pitch the machine needs an upward camera to repeatably place the parts. You will always lose the first 10 or so parts with cut tape but that should be about it. Repair par
Electronics Forum | Fri Dec 08 21:26:44 EST 2006 | billwestiet
You already have some good answers. A chemical isolation zone for RMA is a good idea. If you are looking for new see the two references you have and Austin America. If you are looking for used, see us at http://www.ietechnology.net. We presently