Electronics Forum | Fri Dec 27 16:12:54 EST 2019 | anteiv
thank you for reply here is picture of the board https://imgur.com/a/i2MfFBw on the bottom are pins/components which height is about 3-4 mm from bottom of the board we had to increase distance of board from nozzle to make clearance and we increas
Electronics Forum | Fri Feb 07 11:06:50 EST 2020 | rgduval
Start by checking cables. Odd that the C-motor would initialize, but, then, theta fails when you move the Z-motor. Sounds like something's got a loose connection somewhere. Possibly in the connector going into the C-motor. If that's a no-go, try
Electronics Forum | Sun Apr 26 22:47:42 EDT 2020 | autolab
Hello, We would like to manufacture the OBD II port automobile scanner from your firm. What we need from you? To manufacture the PCB, stuffed the components inside and manufacture the housing. Manufacture few samples, then thousands. What we h
Electronics Forum | Wed Apr 29 09:27:49 EDT 2020 | zombee
Dear friends, We have a pack of Philips/Assembleon pick and place machines, from CSM and GEM series. I want to set up a "new" Emerald machine, it had been working in Germany 1.5 year ago. It has 3-phase connector. I noticed that it was set
Electronics Forum | Mon Oct 12 01:20:42 EDT 2020 | azdback
LandrySMT, after monitoring the errors and considering what we replaced, I also decided to replace the Z hydra motor and encoder. That fixed our problem. I looked at your message and I agreed that the next step was to replace this part. We ran hi
Electronics Forum | Mon Jun 29 16:03:24 EDT 2020 | spoiltforchoice
I certainly can on the Paraquda and I suspect the basic algorithms are the same. Slimmer annular rings such as you might get on a plated via hole don't always image quite as well but if for some reason it doesn't pick it up you should be able to inte
Electronics Forum | Thu Sep 03 21:49:20 EDT 2020 | kylehunter
> Not in our case, the pre-heat temp was not high > enough. Also our pre-heat is only from top > (KISS104). Ahh that makes total sense. We have bottom IR, and have thermocoupled at 100c, so I think we should be good on that end. Anoth
Electronics Forum | Sat Sep 12 02:16:41 EDT 2020 | jmelson
Arrgh, that's an SFA-410ED camera, original subject was wrong. Hello, the down camera on my Quad QSA-30 has gone haywire. It still puts out video, but does not sync to the vision system, the picture rolls horizontally. I have verified the vision int
Electronics Forum | Wed Sep 30 21:48:13 EDT 2020 | kylehunter
> If you could change the design, a 2x25 1.27mm > pitch surface mount connector is a standard part > from Wurth. Samtec also do versions in any pin > count you might desire, with locating pins, > without, with picking clip etc.
Electronics Forum | Thu Dec 17 15:53:32 EST 2020 | dwl
for option 3, if you place the connectors on the first pass then flip the board, won't the protruding leads interfere with second pass stencil printing? My vote would be to overprint onto the solder mask. you can print pretty far and still have it w
.gif)
