Electronics Forum | Sun Oct 09 08:28:04 EDT 2005 | davef
First, no one knows very much about the relaibility of Pb-free assemblies, much less Pb-free solder with Pb-bearing components. Second, we do know that Pb-free components work with PB-bearing solder. Third, based on comparison laboratory testing,
Electronics Forum | Wed Oct 12 04:29:38 EDT 2005 | rlackey
We've seen issues with Elco's for years on boards with a lot of copper (higher than normal temperatures. We found that the 250C caps failed on the "burn in" tests as they has lost a lot of electrolyte in the reflow process. On some brands you could
Electronics Forum | Thu Dec 15 07:55:24 EST 2005 | bobpan
Calibrating the fixed camera (this is the camera that is mounted in the feeder base), I dont recall there being a procedure for calibrating it. You need a special nozzle and a plate that sits on top of the camera and you calibrate it in the system se
Electronics Forum | Wed Oct 26 10:35:04 EDT 2005 | mmjm_1099
Hello all, I was wondering if anyone is using a program or steps for converting your bill of material to a lead-free state. I am looking into changing some of my current customer based parts to lead-free but was wondering if theres a simplier ste
Electronics Forum | Tue Nov 15 14:31:59 EST 2005 | Samir Nagheenanajar
Back in the days when I was in charge of a Paintline Dip conformal coater, I had the same issue with a non-hermetically sealed Potentiometer. We tried to use rubber boots, but the capillary/wicking action of our silicone-based heat cured coating was
Electronics Forum | Thu Oct 27 08:27:57 EDT 2005 | Adam
Hi We are trying to solder a a contact whose base material is stainless steel, this is then nickel striked with a gold plating of upto 3 microns. We are trying to hand solder this to a standard 1.6 FR4 PCB with a HASL finish. We are seeing problems
Electronics Forum | Thu Oct 27 13:22:30 EDT 2005 | moonshine
All solder pastes are worth consideration depending on your needs. What do you need to do? When you know this, run the experiment and determing what best works. I never have found a situation when/where Indium or Kester has failed to perform. This,
Electronics Forum | Fri Oct 28 09:44:11 EDT 2005 | PWH
I'm considering buying a UIC Advantis P&P machine. I'm worried about the huge, additional cost of new feeders. We've been running GSM's for years so we have tons of GSM vibe bases, tracks and feeders. UIC tells me that old pneumatic GSM feeders ca
Electronics Forum | Mon Oct 31 13:22:21 EST 2005 | Luke
We have recently undergone perhaps the largest series of upgrades possible on these machines. This was a technology and cost based decision. Altough we had some issues, the main point I would make is not everything is/can be tested. There should alwa
Electronics Forum | Tue Nov 01 20:11:59 EST 2005 | KEN
Even Quad couldn't get the machines running right (chuckle). If it takes a Quad Field Service Engineer to run a machine what good is the machine? I suspect you have little experience with other equipment makers. Which explains your fierce alleg