Electronics Forum | Wed Jul 14 10:46:58 EDT 1999 | John Thorup
it's just so slow. yesterday afternoon and this morning i have had to leave the site because the delays, timeouts and other errors. what's up?
Electronics Forum | Wed Jul 14 05:54:57 EDT 1999 | Larry Jeter
I have been recently playing the the different bump process within the Universal GSM part data software. Can anyone explain to me the differences between bump process A and E? Any feedback would be helpful
Electronics Forum | Tue Jul 13 18:18:39 EDT 1999 | King Kong
Hi All, Does any one experienced the solder on gold finger after reflow. Its about 5 to 8 mils diameter . We'd clean the entire screen printer, mounter & reflow as well, but doesn't help much.
Electronics Forum | Tue Jul 13 17:05:41 EDT 1999 | Stephen Surtees
Looking for a conversion factor for resistance to convert MKS units to/from CKS units thanks
Electronics Forum | Wed Jul 14 09:17:09 EDT 1999 | Dave F
| Looking for a conversion factor for resistance to convert MKS units to/from CKS units | | thanks | Steve: A volt per ampere, called an ohm, is MKS. The following link can probably help you get to CGS. Ta Dave F
Electronics Forum | Tue Jul 13 15:58:46 EDT 1999 | Jennifer
Does anyone have a US or North American phone and address contact for EKRA (Eduard Kraft)? I have been told by several people that there is a small office here in the US, but so far I've been unable to locate it. Any assistance is appreciated!
Electronics Forum | Tue Jul 13 14:02:30 EDT 1999 | Mohit Gujral
Folks, I was wondering if anyone could tell me where I can get information on NCJ standards. The name "NCJ" sounds fimilar but I can't place it - anyone?? Regards, Mohit
Electronics Forum | Tue Jul 13 11:32:03 EDT 1999 | Chrys Shea
I tried to download Ed Smith's paper titled "Lead Free - a push in the wrong direction?" today, but it wasn't there for downloading. Could this be suffering from the same issues I had with my last paper, in that the file size was too large and it ne
Electronics Forum | Tue Jul 13 03:30:46 EDT 1999 | George
Our plant in Slowakia tries to convince me that it is not possible to reflow FR2 PCB-material. At this moment the PCB's leave the reflow dark coloured and they are schrinked. I'm still waiting for a reflow profile, because I can't believe that it is
Electronics Forum | Mon Jul 12 13:27:35 EDT 1999 | Upinder Singh
Hi all , We are trying to implement the micro-BGA technology at our plant. I need the clarification to the following points: 1. Is underfill required for micro-BGAs? 2. What type of stencil apertures are the industry standards for uBGAs and of wha