Electronics Forum | Fri Sep 19 11:59:57 EDT 2008 | john_smith
Ralph, Is this problem related to all product or is it product specific? You may need to change the fiducial data in the program. I am not familiar with flexa but have some knowledge with MCS30.
Electronics Forum | Fri Sep 19 13:22:33 EDT 2008 | evtimov
Hi, if it is for all your products, for me it looks like a camera cable or camera problem. You are loosing connection and get the message. FFFC looks like a fatal error. If it is only one product, play with the lighting and treshold. Regards, Emi
Electronics Forum | Fri Oct 03 01:01:09 EDT 2008 | khushi
Dear All, I would like to know that what are the problems which will be encountered while mounting 01005 components & BGA's on the PCB for thickness 0.2mm and what will be the processes involved in mounting the components.
Electronics Forum | Thu Dec 04 15:40:05 EST 2008 | dougt
Do a search here for SMEMA standards, I had problems a while back and had to swap some wires on an OEM's machine to get it to interface correctly to our equipment. Probably not the same problem as your having but I did write a long winded explinatio
Electronics Forum | Wed Jan 14 07:32:15 EST 2009 | mosborne
They claim that they confirmed this with PPM. I plan to be at this site next week so I cna have a look for myself. I thought also a potential encoder until they said the problem went from y to x. I have replaced encoders that cause this problem in th
Electronics Forum | Fri Mar 13 05:12:06 EDT 2009 | geb
Hi, Does anyone have problems with the cover tape not peeling back on the 8mm wide feeders. We often find that particularly at the start of the job, the cover tape doesn't peel back causing mis-picks. Thanks, Grant
Electronics Forum | Thu Apr 16 11:58:20 EDT 2009 | ccross
We have seen this exact same problem. Our vendor agreed it was their problem and also agreed it was a moisture issue within the PCB layers, not the solder mask. We have taken to baking our boards, especially when they are manufactured during the late
Electronics Forum | Fri Apr 10 11:40:09 EDT 2009 | kenlowe
I have a Microjoin HCD-125 power supply for a resistance welder and it is not Welding, apparently I am not getting any welding current, Could this problem be with the programming of the unit or a fault wih same. if so how can I isolate the problem? T
Electronics Forum | Wed Apr 29 01:38:38 EDT 2009 | nibirta
already did this test. No solder balls. i have printed the pads without the component. No solder balls. Only with the component. The problem is, it splashing the around components. solder balls wew found on the body of a connector and on top of it. T
Electronics Forum | Wed Jul 15 12:40:40 EDT 2009 | thanhnguyen
check your vacuum valve, manually turn it on and off,i have the same problem like that b-4, after replacing the vacuum valve, the problem went away.
