Electronics Forum | Fri Dec 01 13:55:44 EST 2017 | emeto
Brikainis, it looks like these vias are not plated and closed. I would say that thickness of your paste is lifting the part. Are you willing to try another stencil with ground pad apertures matching the via holes? It is probably worth trying. Anothe
Electronics Forum | Tue Nov 28 11:58:58 EST 2017 | emeto
Hello all, I am about to design a panel and there are two connectors on the board that seem to be very close to the edge of the board. I am worried that they might interfere with the cutter blade. Can you tell me how close do you think a part should
Electronics Forum | Thu Feb 15 02:27:51 EST 2018 | ameenullakhan
Thanks for the wishes BOB. I am into process engineering. We don't contact the customer. SMT Line support. Customer might approve also. But our own quality team says its profile issues :(. Will see.what more can be done from our side. Thanks, Ame
Electronics Forum | Tue Jan 16 12:14:35 EST 2018 | emeto
There is no reason why you can't see these leads clear. Isn't there any way you can play with the lighting? I used to have Siemens machines and I want to say that it was possible. Go on the machine, start editing this shape code and find where you ca
Electronics Forum | Thu Mar 08 15:31:49 EST 2018 | jdengler
If you buy old equipment like these I would recommend buying from one of the companies that advertise here. Make sure it's one that has staff to support you. Some will say they have staff but they actually use contractors. That's not always bad bu
Electronics Forum | Tue Apr 10 04:34:26 EDT 2018 | stephenj37824
I must say so far the yamaha seems to fit the bill. Most of our products are low mix. Less than 6 different components per board. 90% are only 2 lol. So just looking at how the yamaha operates it seems gang picking the same part off 12 feeders seems
Electronics Forum | Thu Apr 19 18:38:05 EDT 2018 | slthomas
I would say not likely unless it's at least serialized, but certainly so if it requires calibration....point being LOTS of stuff requires calibration for AS9100 activity. Simple hand tools probably not, for example, but your calipers, multimeters w
Electronics Forum | Mon Jul 30 01:14:37 EDT 2018 | erici
Our DEK 265LT wont boot up with the DEK software. It says that the current version of the software can only run a 265GS printer, and to install the correct release of the software. Has anybody encountered the same problem? It just started happenin
Electronics Forum | Tue Feb 19 14:07:29 EST 2019 | slthomas
I figured it was just going to take a little searching to find a (more expensive) stamp that used an (more expensive) indelible ink. Not the case. Just can't find anything at all, and the stamp manufacturers say not to use any ink but what they provi
Electronics Forum | Thu Feb 21 13:50:26 EST 2019 | s197seth
I am trying to do a Pass Through and the DEK wont send the board to the Conveyor and it says its waiting for downline transfer even when the SMEMAs are tripped. and on the Multi - Interface Unit, the light next to downline ready is not on. Any help?