Electronics Forum | Wed Dec 14 08:46:58 EST 2011 | cbroegger
Hi, we use some camera based readers, they can scan all barcodes in a square of roughly 10 x 10 inches. We have some pcbs with 3-4 barcodes (linear, 2D barcodes), and it can read them all in one take. I can find more information if you need that.
Electronics Forum | Wed Jan 11 06:29:47 EST 2012 | cbeneat
We have Vectorguard frames we've been using for about 6-8 months. We've seen no leakage on ours. The frame has written on it an operating pressure of 101.5-116.0 psi,our pressure is set a lot lower, 50-60 psi, as we also use another frame that can'
Electronics Forum | Wed Mar 21 21:42:31 EDT 2012 | aoiguy
With the above information given on how to repair, I'd make sure to send a photo to the customer to see if they even want it repaired in the first place. Experience has shown that some customers just won't take product that has been damaged no matter
Electronics Forum | Fri Jun 08 17:06:41 EDT 2012 | tombstonesmt
We have many Pillarhouse Jade Mark II's in our facility. Lately design engineers have taken a liking of huge ground planes in boards. Quite honestly with topside heaters some of these boards were impossible to solder. True you can preheat with the no
Electronics Forum | Fri Jun 01 16:13:45 EDT 2012 | kahrpr
You also need to get with the PCB manufacturer. Their is a lot that can go wrong with that many layers. If the manufacture is trapping that much moisture. you may have a hard time baking it out. Dave and Graham are right about the time and energy. It
Electronics Forum | Mon Jun 04 08:53:44 EDT 2012 | mosborne1
Sounds like the boards were not properly manufactured since you have baked them prior to assembly. We just had a customer return from China becasue of this issue. We have made 10K without issue. Let me take a stab and ask if they were made in the USA
Electronics Forum | Tue Jul 17 10:47:54 EDT 2012 | upguy
As as per your information and photo, we attached two box fans under our booster and attached them to the white XGTS connector. The fans are blowing upward with airflow between the booster board and the back of the machine. We will carefully watch
Electronics Forum | Wed Jun 13 01:01:10 EDT 2012 | isd_jwendell
I clean all fids with a fiberglass brush pencil so that I know there will be no rejects (it doesn't take too long). The problem is the machine lighting. My Essemtec machine uses a light ring (red LEDs) around the cam. Here's one of many documents th
Electronics Forum | Wed Aug 08 14:32:50 EDT 2012 | leemeyer
According to Quad data sheet, the max process temp on a ZCR oven is 310C. I am taking a guess that the "Critical Temperature" message may be Quad's way of saying that you have entered to high of a setting. Try bringing the setpoints to something belo
Electronics Forum | Tue Sep 18 05:54:02 EDT 2012 | sarason
Have you got some modern software to load the unit. My program PCB Synergy can do some of the Panasonic formats but not this one. It takes less than a day to write if you have some files for me to reverse engineer and the file you read it from. Any