Electronics Forum | Wed Aug 01 13:35:41 EDT 2018 | tey422
Need all your experts out there for tips & tricks to make things work. I been giving a task to help redesign a simple board; only to load two components. The challenge is to use pick-n-place machine to load the coil onto the 50up array panel. Previou
Electronics Forum | Thu Jun 07 17:17:58 EDT 2018 | emeto
If you are a good mechanic they are all Toyotas. Pick one that has at least free phone support. Take all the necessary training or include them in your machine deal. I had UIC, Juki, Fuji, Siemens, Mydata ....and some other European brands. All of t
Electronics Forum | Sun Feb 12 03:06:04 EST 2012 | dan_ems
Please help me with this: I need a zero Ohm SMD resistor (strap) to connect 2 PCBs but to be like a wire, that can be bent. I need to be SMD because I want to be place it with "pick and place machine". Thank you.
Electronics Forum | Thu Dec 03 14:51:57 EST 2015 | proceng1
The problem we ran into trying to do more intrusive reflow is that many of the TH parts could not withstand the temperatures for the reflow cycle. Solder preforms that could be placed by the Pick and Place was one of the avenues I explored trying to
Electronics Forum | Wed Nov 29 20:32:08 EST 2000 | irwanm
I'm new in SMT and the company I'm working with has already purchased SMFL-3000 manual pick & place system with hot air and we don't have reflow oven. We are now starting design SMT board. My question is, how we reflow the solder? After all component
Electronics Forum | Tue Jun 19 13:49:08 EDT 2001 | Ben Brandt
Hello everyone. I'm trying to locate (if it exists) an impact sensor (which would activate if hit or jarred) on some sort of roll form with 2 leads which could be easily placed and soldered through automation. If anyone knows of a supplier, I would v
Electronics Forum | Tue Dec 20 07:58:32 EST 2005 | dwensker
Thank you all for your info. Our problem is fixed. We did as you mention: - chuck set correctly on the collers, Wide jaw Soft spring & Narrow jaw hard spring - make the pick-place soft - slow down the speed controllers for both descent and ascent r
Electronics Forum | Tue Jul 18 11:32:40 EDT 2006 | Joris Groot koerkamp
I am wondering what skills operators need to run an smd line itself. At our company they know how the pick&place machine works (refill/ changover), but if there is a problem with wrong placed components they don't known what to do. Our managmenttea
Electronics Forum | Wed Nov 07 01:59:24 EST 2018 | robl
Hi Reckless, I'd feel uncomfortable placing that part as I've only ever used Sapphires as chipshooters and LED placers, not that I don't believe it can't do it, I just haven't personally done it on that machine. We always had multi machine lines. I
Electronics Forum | Wed Aug 03 07:29:03 EDT 2022 | pradeep14
Hi, We are facing the issue with Component orientation(Wrong orientation), during Proto build/NPI time in SMT for 1st board placement. We are not doing 1st board with STICKY board, directly placing the components with Paste board only. Pls suggest, H
Lewis and Clark is your #1 Pre-Owned Surface Mount and In-Circuit Test equipment supplier. We offer a variety of equipment solutions at a significant cost savings over new.
Manufacturer / Equipment Dealer / Broker / Auctions
18 Celina Ave., Unit 16
Nashua, NH USA
Phone: (603) 594-4229
