Electronics Forum | Thu May 13 17:08:38 EDT 2010 | gregcr
prompt appears hit enter, another prompt should appear. Now set Diagnostic/Run switch to run, start vision system software load. The vision software can not load if the system is in running arbitrary code and hung in a loop so halting the controller
Electronics Forum | Fri May 14 02:04:16 EDT 2010 | dilogic
Sorry for not clearing that out - it's not the problem of lost vision sw. - I even can't connect to it in diag. mode. Must be some hardware issue. I've checked video outputs with the scope and instead of constant freqency ~15kHz, it drifts up and dow
Electronics Forum | Wed May 19 17:54:41 EDT 2010 | gregcr
I have had problems corrected by swapping or replacing the power supplies in the box. Do you have a second GSM that runs the AIS3500 box? If so swap the power supply and see if the problem follows the swap. I have replaced the supplies inside the
Electronics Forum | Tue May 11 10:58:51 EDT 2010 | davef
Paste for dispensing differs significantly from paste for printing. [B Toleno Henkel Loctite]. So, if you compare paste characteristics: Characteristic of paste||Printable ||Dispensable Viscosity [million centipoise]||0.8 to 1||0.2 to 0.4 Metal cont
Electronics Forum | Tue May 11 14:17:55 EDT 2010 | isd_jwendell
Getting the paste from the jar and into the cartridge without entrapping air can be difficult. Can you not just transfer the 500g jar into smaller working jars? This way you can keep the bulk of your paste refrigerated until needed. Air is not your f
Electronics Forum | Thu May 13 01:41:31 EDT 2010 | nrw
Thank you everyone, I realise the problems now and the whole exercise might not be worth the money saved, versus just throwing out the leftover paste. I am based in Australia, so the number of players in this market is small and they know it. The pr
Electronics Forum | Sat May 15 11:27:26 EDT 2010 | davef
We'd expect both OSP poor wetting and improper reflow recipe to show-up in more places than just this one component. But if those are the only choices, we'll go for 'wrong solder paste.' Ooops, that's not one of the choices. Ok, OK, we'll take poo
Electronics Forum | Fri May 14 12:44:26 EDT 2010 | padawanlinuxero
Hi Since we are a small company with a small smt line, we did not have problems with our stencils because they are small and could clean them with Alcohol and wipes, but now we are growing, and now I am having a 20X20 stencils frames to deal with,
Electronics Forum | Mon May 17 12:46:43 EDT 2010 | flipit
Big problem. Certain LED from certain manufacturer sticks to the tape and reel cover tape. Peel back the cover tape and every LED lifts out of the embossed pocket and sticks to the cover tape. I believe this is from static and not any sort of adhe
Electronics Forum | Tue May 18 11:22:24 EDT 2010 | flipit
The ionizer was something we thought about right away. I need to investigate further. Somehow I need to get the ionizer mounted on the chipshooter. An oldschool chipshooter. A turret machine. My other concern is can I blow the ionizer at the par
