Electronics Forum | Wed Mar 23 10:16:47 EDT 2011 | blnorman
If these are moisture sensitive they are required to be shipped in a moisture barrier bag and labeled as moisture sensitive. Depending on which moisture sensitivity level (MSL) the components have, floor life can range from unlimited to a mandatory
Electronics Forum | Thu Nov 10 10:15:40 EST 2011 | davef
J-STD-003 describes the test methods and gives guidelines for assessing the solderability of bare circuit boards
Electronics Forum | Thu May 31 10:25:19 EDT 2012 | edmaya33
J-STD-001E, 8.3.6.2 states 1.56um/cm2 NaCl value.
Electronics Forum | Thu May 31 21:43:44 EDT 2012 | davef
edmaya33, you're correct about what J-STD-001E says, but recognize that the measure that you refer us to in not IC [Ion Chromatography]. It is modified ROSE [Resistivity of Solvent Extract] ... or whatever they call modified ROSE now-a-days
Electronics Forum | Fri Oct 26 17:20:15 EDT 2012 | joeherz
Hello, I need to find a wire tinning pot with temp control that will conform to J-STD-001 requirements. I'm looking at American Beauty and Plato models. The American Beauty models appear to be capable but the low prices make me wonder. Any advice
Electronics Forum | Fri Feb 15 14:45:30 EST 2013 | davef
Yes, the standard applies to things that are soldered. Read this ipc.org/TOC/J-STD-002C.pdf BR, davef
Electronics Forum | Fri Feb 15 16:56:46 EST 2013 | davef
I'll throw my hat in the ring that says, "At least 95% of the pads must be properly wetted." BR, davef
Electronics Forum | Wed Feb 20 12:44:21 EST 2013 | davef
From IPC APEX ... Hege is correct ... ALL pads have to be 95% wettable or better. BR, davef
Electronics Forum | Mon Feb 25 15:14:42 EST 2013 | bmario
Thank you guys! I will use this interpretation. However it is hard to meet when using the wave method.
Electronics Forum | Thu May 23 18:10:54 EDT 2013 | davef
I agree with Rob. These solder connections are unacceptable. BR, davef