Electronics Forum | Fri Jun 04 12:23:04 EDT 1999 | tannlin
| | We are looking into frameless stencil systems for screen printing. Outside frame size of 29x29. | | | | Pros: smaller storage requirements and cheaper stencils. | | | | Cons: sharp metal edges, additional change over time required | | | | Can
Electronics Forum | Thu Apr 09 22:50:50 EDT 1998 | Larry
Configuration of our HP 3065 in-circuit tester: HP3065 HL testhead with CL+ controller with 2 hard drives and tape drive 11 Hybrid cards 4 Analog cards 1 GP relay card 2 DUT power supplies (6038A) 1 HP color terminal (2397A) 2 HP terminals (700/92 an
Electronics Forum | Mon Apr 20 10:20:37 EDT 1998 | Joyce Hughes
| | Configuration of our HP 3065 in-circuit tester: | HP3065 HL testhead with CL+ controller with 2 hard drives and tape drive | 11 Hybrid cards | 4 Analog cards | 1 GP relay card | 2 DUT power supplies (6038A) | 1 HP color terminal (2397A) | 2 HP t
Electronics Forum | Sat Jan 05 00:13:16 EST 2002 | Chris Veeneman
I have experienced the same problem with my Mark 3. I found the problem to be the solid state relays in the electrical control panel. Towards the front of the machine below the breaker rails. My oven's computer screen would show all was fine but my
Electronics Forum | Fri Jun 28 03:04:21 EDT 2002 | Dreamsniper
Forgot to include the following: Dwell time is from 55 secs to 68 secs. Indium specs for the paste is maximum peak @ 228'C and 30 to 90 secs dwell time above 183'C. PCB is a 6 layer board with Dimension of 205 x 166 mm but is slightly dense with 11
Electronics Forum | Wed Dec 03 03:11:09 EST 2003 | ADAM
tHANKS FOR THE RESPONSE GUYS. I'll be checking out those websites during the day Cal. With regards to youR response Daniel. All our soldering materials are Alphametal products and are RMA based. As much as we would like to use ultrasonics on all our
Electronics Forum | Wed Feb 18 16:38:47 EST 2004 | agp
Dean,Chris,Steven, Thanks for all your inputs. I have met with our smt staff and scheduled an evaluation by early next week based on your suggestions. I'll be happy to relay positive feedback afterwards. To be more detailed, here are our set-ups as
Electronics Forum | Sun Apr 11 20:03:46 EDT 2004 | Tom B.
You should add a Capacitor Discharge statement in ICT test Software. This could be done by selecting the nodes and have statements to connect relays to ground. Could be possible that the Selective Soldering system is the cause, as problems is now s
Electronics Forum | Fri Sep 16 06:34:07 EDT 2005 | ajay
We have link fail issue now & could not able to establish. Overall situstion is that oven can not work. we checked all relay 24vac, 24vdc, 110v, 120v, 240v. all looks ok. only issue we ovserve that from B250SSR pin no 3&4 we are unable to get 5VDC. T
Electronics Forum | Fri Dec 22 09:19:11 EST 2006 | simonlee
Our VIP98 oven just refused to do anything this morning, no previous history of problems. Conveyor and heaters do not start up. None of the Solid State Relays in the back of the unit are operating, although we can make them switch by wiring up to t
