Electronics Forum | Wed Feb 03 22:29:08 EST 2010 | mika
via apertures > solderding of terminals to the pads! That is zero which means => 90 % solderjoint Terminal to pad! http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=13914&#Message58952
Electronics Forum | Wed Feb 24 21:01:34 EST 2010 | davef
You're correct, CPH doesn't mean dip. You want: * Perfect parts. * On-time delivery. * Cpk ~2 each quarter * Zero lost machine time as a result of product change-over. ... Right?
Electronics Forum | Wed May 05 20:58:40 EDT 2010 | aungthura
Hi Stephen Our boards are as large as 600x600mm and sometimes 8 or 12 layers thick.And,there are many various components in different material.So, we are seeking the soldering machine which can supprot zero delta T.Thus, we consider to try with Vapor
Electronics Forum | Wed Aug 18 11:12:04 EDT 2010 | davef
So with your mounting frustration in your inability to zero-in on the factors that drive your solder balling, are you thinking that maybe you need to bite the bullet and design a experimental study to help isolate the key drivers to your solder balli
Electronics Forum | Thu Aug 26 15:44:56 EDT 2010 | namruht
Is there ever a point in the life span of pick and place equipment when you can expect the machine NOT to be able to produce at a zero defect rate.
Electronics Forum | Fri Sep 03 08:25:30 EDT 2010 | remullis
I removed the muffler yesterday and still had the latch releasing issue, the latch was tight, however the table had some play in it. I adjusted the play out of the table, setup table zero and it fixed the problem. Same symptom as if the latch were lo
Electronics Forum | Fri Mar 04 18:08:26 EST 2011 | eadthem
There is a option to enable no good marking that must be enabled on the board options where you reset your board count and images. dose the marker zero on startup?. If not then it may also need enabled in the inspector settings. ead
Electronics Forum | Wed May 11 14:02:53 EDT 2011 | pct1410
I am looking for a used Aqueous Technologies' Zero-Ion Ionic Contamination Tester. If anyone has a used one for sale please contact me! Thank you
Electronics Forum | Wed Nov 09 09:18:28 EST 2011 | edmaya33
VIT 5K is the best. zero falls calls and effective for pre reflow process. Programming is very easy ( VI pro, edge, blob etc ) 4cm per fov.
Electronics Forum | Tue Nov 15 22:08:58 EST 2011 | nevercry14
Thats the odd part that i can zero set no problem just when i try to run idle the sz sensor ok when goes down but when it goes back up its not bieng retracted up so sensor stays off n eror acurs again any ideas.
