Electronics Forum | Mon Jan 28 07:48:18 EST 2002 | cnotebaert
Did you perform a cleanliness test on the boards? did it pass? if yes whats the issue? visual attributes like this will not effect form fit or function of the device. Finding this under 30X, wow, why 30X????
Electronics Forum | Mon Jan 21 08:47:36 EST 2002 | pr
The nozzle shafts are different (and windmill/ head), cutter blades and assy. are different, that's all I can think of off the top of my head. Also slightly slower than a CP64. I believe the 65 and 65000 are the same.
Electronics Forum | Tue Jan 22 20:27:28 EST 2002 | davef
Doesn't sound good does it? Consider using your field meter to determine the charge level generated in handling these connectors. Then you can determine the impact of the charge generated and the best handling approach.
Electronics Forum | Tue Jan 22 07:34:07 EST 2002 | cabjerk
Hi All; We are having problems finding software for off line programming of our GPD machine. We have talked to GPD and no luck. Any leads out there? Thanks Carl B.
Electronics Forum | Tue Jan 22 20:30:44 EST 2002 | davef
Start with the following: * Aegis ISC (Circuit CAM) * Mitron (GenRad) (CIMBridge) * CAE Technologies (C-Link)
Electronics Forum | Mon Jan 28 17:34:32 EST 2002 | PeteC
The product mentioned by SmartSonic (stencil cleaner maker) is from ScanCAD International. See http://www.scancad.com
Electronics Forum | Tue Jan 22 20:34:41 EST 2002 | davef
Other on-line electronic assembly sites have no juice. This is it. We have wave soldered since 1982. What's the issue?
Electronics Forum | Thu Jan 24 04:06:12 EST 2002 | wbu
Shawn: So, when was your last solderanalysis and what were the results ? Did this phenomenom occur just so, out of nowhere, and is it with all your boards? Just missed these points in your request. Wolfgang
Electronics Forum | Tue Jan 22 20:37:48 EST 2002 | davef
Try: * Searching the fine SMTnet Archives. We have ground profiling, thermocouple attach, etc. to pulps. * Buying [ http://www.ipc.org ] IPC-7530 - Guidelines for Temperature Profiling for Mass Soldering (Reflow and Wave)
Electronics Forum | Mon Jan 28 07:34:21 EST 2002 | cnotebaert
Yes, there are a few companies that make de-paneling equipment, Cab is one of the larger they make scoring and tab de-panelers. Just keep in mind regardless to what type of equipment is used if the parts are to close to the board you still run the ri
