Electronics Forum | Fri Jun 06 16:25:03 EDT 2014 | spitkis2
Component manufacturers subject their lots to thermal / reflow testing per IPC /JEDEC STD-020. This involves running the parts through an oven 3X with a peak above 260C. I am not certain if passives go through the same test (theoretically they shou
Electronics Forum | Wed Jun 11 16:52:17 EDT 2014 | aybars
yes, you should look to see on that particular feeders Z axis setting. When the tip goes down to the part it may be traveling down little too much. Just make sure you check which way is your - and + increments going and do not exceed more than 30 or
Electronics Forum | Fri Oct 17 15:23:28 EDT 2014 | davef
First, don't exceed the maximum temperature of the battery, say 85*C [I don't know your specifics] Second, don't short the terminals of the battery. Third, the best way to wave solder a battery is: * Insert an insulating tab between the battery an
Electronics Forum | Mon Dec 22 16:20:03 EST 2014 | warwolf
Basically the contract comes first, then the design drawings then IPC. if your costumer is asking you to bend the PCB then it becomes apart of the design drawings. as for looking for a cover, get it in writing that that's what they want you to do. I
Electronics Forum | Fri Apr 10 12:23:27 EDT 2015 | utosun
The recommended wash concentration for stencil cleaning with VIGON SC200 is 25% and this should be confirmed using the ZESTRON BA-20 bath analysis kit. Additional cleaning recommendations are: Wash temperature should be approximately 25 degrees C. /
Electronics Forum | Thu Aug 13 13:48:22 EDT 2015 | markhoch
Hi Juan, I think if you check your Solder Paste's Data Sheet, you will find that your Solder Paste can be stored at Room Temperature for up to four weeks. There is no need to put your paste back into the refrigerator after every shift. If it makes
Electronics Forum | Thu Jun 02 09:33:50 EDT 2016 | emeto
Hi, if I were you, I would probably go for testing and rework equipment. Adding manufacturing to your business, will most probably exceed your preliminary expectations. Manufacturing is much more complicated than you probably think. I have used manu
Electronics Forum | Thu Dec 08 01:44:44 EST 2016 | cmarasigan
We are currently experiencing with our SMD Solder Reflow Equipment on Shooting-Up Zones (Zones 3,4,5,7 & even Cooling Zone). PV exceeds about 5-10 degrees with the SP. (ex: SP=140deg, actual PV = 145deg & higher). Our equipment undergo a monthly prev
Electronics Forum | Wed Dec 20 10:44:31 EST 2017 | bobpan
The z-rod bellows on head 2 and head 3 are slightly bent. The machine will show you this error if the runout is over 6.5 mils. This is usually caused by too much z when picking parts out of a vib or tray feeder. The machine will probably run. I ha
Electronics Forum | Tue Mar 27 02:37:35 EDT 2018 | rob
Hi Thomas, Yes, we are pretty good at feeder maintenance, we gang pick on our Yamaha/Assembleon kit with no issues. On one of our older machines (YV112-3/Sapphire) we pick 12 LEDs at once per side of the machine. On a couple of jobs we exceed the ma