Electronics Forum | Mon Aug 14 15:00:20 EDT 2006 | russ
I have used Martin, Metcal and Ersa. I would go with the Metcal. i thnk you get the most bang for your buck withthis unit. Martin service and support can be taxing on the Mind if you are in US. fairly decent unit though. would recommend if you l
Electronics Forum | Tue Sep 12 21:04:42 EDT 2006 | C Curk
You should look into the ACE Unit. Best unit on the market. Sells complete for $55,000. HAndles a 18 x 24 board, 1MM keep away area. Made in teh U.S. too. Email me at clcurk@att.net I can email you a link to the site.
Electronics Forum | Sat Dec 16 08:23:11 EST 2006 | pr
The "Wave optimizer" is a little pricey but is easy to use, gives instant feedback (display on the unit as opposed to hooking it up to a computer)and will give feedback on the waves, as well as preheat. They will send you a unit to trial for a week o
Electronics Forum | Fri Jan 19 13:31:14 EST 2007 | lit51
Is the failure just out of tolerance or is it non functioning? For tolerance problem, compare the x-rays of the good and bad units. It will take a very high resolution x-ray to spot the differences. Changes in capacitance values can occur based on
Electronics Forum | Mon Jul 02 09:30:19 EDT 2007 | cyber_wolf
Make sure that your C14 tool is black and that the tip is in good condition. Next, create a vision package for the 0402. I assume that your machine has a line scan camera.(Use it) 0402's do not mechanically center well unless your C14 and centering u
Electronics Forum | Tue Oct 02 07:48:16 EDT 2007 | brendansales
Hi there, Does your computer has a product key (USB) by any chance? there are some units that requires a USB key. alternatively you can check if the controller has been opened before (you can check if the sticker has been torn), or you can try swit
Electronics Forum | Tue Jan 29 15:03:14 EST 2008 | clampron
We have a Kic 2000 9 channel. The options for this unit were 9 or 12. I do not remember what we paid for it but the Kic Navigator and its prediction capabilities really reduce required profile time. I have also used Datapak and Mole but not for year
Electronics Forum | Wed Mar 12 07:43:02 EDT 2008 | grantp
Hi, Thanks for the advice, and we are doing about 4000 units a month, with multiple BGA per unit, so manual inspection is totally out of the question. It sounds like the replies from people doing volume work seem to think it's a good option. I agr
Electronics Forum | Mon Jun 16 13:51:13 EDT 2008 | dyoungquist
We are adding water soluble flux in our manufacturing. I need to add an ultrasonic cleaner to clean the pcb assemblies. I am looking for a table top unit that can handle boards up to 10.5" x 17". We run high mix/low-medium volume. Any suggestions
Electronics Forum | Mon Sep 21 11:29:52 EDT 2009 | edmneb
The part we are looking for is the touchscreen controller manufactured by Microtouch. There is no specific part number called out in the UIC drawing book, but the part that we found on the PCB of the Microtouch unit was 7209401. We did swap the con
