Electronics Forum | Mon Oct 21 19:17:23 EDT 2013 | hegemon
The first picture shows an issue. Note that the vias adjacent to the interior rows are filled with solder. At the outside rows this is not evident. What you might have are interior spheres that are smaller in volume than the rows on the outide, si
Electronics Forum | Wed Jul 03 10:37:41 EDT 2013 | sara_pcb
My circuit board contains 11 x 11 matrix 1mm pitch BGA, The device was tested in socket on evaluation Board. We handed over the actual PCB & devices for re-flow. The assembly house first re-flowed all the SMT components other than BGA. BGA was placed
Electronics Forum | Sun Jan 12 09:29:20 EST 2014 | spoiltforchoice
Subtle spamvertising there. Lower Cost small machine brands worth looking at are probably: Mechatronic Intelligent Drives (UK only?) TWS Autotronik or their Manncorp branded models in the USA Fritsch Innotech Heeb (a virtually invisible market share
Electronics Forum | Tue Oct 22 09:20:31 EDT 2013 | swag
Yes, car rims (and brass tubas)! You finally helped me get to the bottom of this expensive issue. We fired the culprit. It's the same guy that was using the ultrasonic stencil washer to clean car parts on night shift. It might be snake oil, I don
Electronics Forum | Thu Oct 17 17:29:46 EDT 2013 | lordofpiggies
Hello. We are building a CCA which has a silicone-based adhesive whose purpose is to bond the bottoms of multiple LED displays to heat sinks. Our customer wants the CCA to be tested for ionic residues per J-STD-001, but we are hesitant to test the
Electronics Forum | Sat Nov 23 12:39:18 EST 2013 | joeherz
We installed a Soltec Delta 3 a few months ago and have been trying to run with a VOC free no clean. We're using SN100C in the pot. We are spraying the material and have top/bottom preheat. Evaporation of the water in the flux is a bit of a stru
Electronics Forum | Mon Jan 20 11:11:24 EST 2014 | fnorradd
I have an Ersa Versaflow selective solder machine (single bath) which runs via a Profibus control system. I have checked all of the settings on the inverter, and all of the connections and outputs throughout the machine, but the machine returns a 68
Electronics Forum | Mon May 26 04:39:49 EDT 2014 | sarason
Damn near impossible. You need to see a real change in the difference between the 2 elements you are reading. So to give yourself any hope run 2 long traces one top one bottom up the length of the board. Then compare to 2 wriggly traces at one end (o
Electronics Forum | Fri Jun 06 13:03:01 EDT 2014 | asksmt
Hi All, i have footprint 2X5 RA HEADER 2MM spacing in design. I am using about 9 mils of annular ring on top side and about 12 mils of annular ring on bottom side. refer picture attached. we are having solder short issues during wave solder so was
Electronics Forum | Wed Jun 11 11:33:26 EDT 2014 | fredcalkins
I do not have machine experience, but I think vacuum too early would be a more likely cause of chips leaping to a nozzle. Juki nozzles are made of hardened stainless and could be slightly magnetic, but the end is relatively small and would not have t