Electronics Forum | Fri Jun 11 16:21:33 EDT 1999 | Dan Perkins
|Jason, The stroke of the cutter blade cam rod is fairly tight, is machine making loud clunking noise when it stops? If so stoke may need to be adjusted. Send me an email if you would like to talk. dan |Yes, I am aware of this machine being a Sa
Electronics Forum | Fri Jun 04 23:44:07 EDT 1999 | Dean
| | Has anyone had a problem with the trailer tape length being too short and causing placement machine to stop for parts exhaust (SMT parts)? I realize the EIA spec. is set for this length but would like to know what issues you have had. Thanks |
Electronics Forum | Sat Jun 05 07:47:47 EDT 1999 | Dave F
| | | Has anyone had a problem with the trailer tape length being too short and causing placement machine to stop for parts exhaust (SMT parts)? I realize the EIA spec. is set for this length but would like to know what issues you have had. Thanks
Electronics Forum | Sat May 29 22:10:28 EDT 1999 | Earl Moon
| We are looking into frameless stencil systems for screen printing. Outside frame size of 29x29. | | Pros: smaller storage requirements and cheaper stencils. | | Cons: sharp metal edges, additional change over time required | | Can anyone relay
Electronics Forum | Fri May 28 15:01:02 EDT 1999 | Tony
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Fri May 28 16:03:10 EDT 1999 | Jeff Sanchez
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Tue May 18 14:47:02 EDT 1999 | Dave F
| Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) | Did some of you guys did some testing on both types and what were your find
Electronics Forum | Sun May 16 10:11:50 EDT 1999 | M Cox
| I'm running memory module product- SMT double reflow ( 12 modules per panel). I'm using the epoxy base solder paste in order to reduce the flux spattering problem onto the gold finger which could lead to the intermittent contact problem. | | I do
Electronics Forum | Thu May 20 10:09:16 EDT 1999 | Eric Maddy
| I am currently an employee of Cabeltron Systems in Ohio. Our manufacturing divisions have been outsourced to Celestica, strictly a business deal. No hard feelings there. Our building is located in Southern Ohio and will soon be vacant with 300 peop
Electronics Forum | Fri May 14 00:28:09 EDT 1999 | Mike D.
| I am seeing reflow around my signal pins after being subjected | to a profile of 204c for 1 minute and 225c for a min of 30 seconds. Signal pins are soldered into a copper plated alum. case with SB5 and then silver plated. The pins have a hot oil
