Electronics Forum | Sat May 24 04:57:41 EDT 2003 | iman
Good Points made. Keen observation. Work-life is mainly about covering Ye arse and keeping the air smelling full of roses. most traceability systems that do cover arse, comprise elements such as : 1) Lot no. control - link to production schedule /
Electronics Forum | Wed Jun 04 20:09:01 EDT 2003 | stefwitt
The tact time is determined by the slowest machine in the line. In your case it is 4.5 min. This is the time from the board leaving the output conveyor sensor to the next board leaving the sensor. The first machine, which finishes the job in 3 min. h
Electronics Forum | Wed Jun 11 16:45:09 EDT 2003 | jgregory
I do not agree. We were even told that if we do not pay, and we need to order parts, that there is no guarantee of receiving the right part number (since we didn't/couldn't use phone support for correct part numbers) and if the wrong part was receive
Electronics Forum | Wed Jun 11 22:56:10 EDT 2003 | jgregory
OK Terrapin, Here it is, roughly half hour after I vented on your reply. I still don't like your attitude to "school" me on this subject. I've been doing this way too long. But I decided that I would satisfy your attempt at "learnin" me. First, I
Electronics Forum | Tue Jun 17 01:27:25 EDT 2003 | Dreamsniper
Hi Guys, I need your opinion here. Has anyone tried doing this Process: Bottomside Process first which means gluing the chip components then reflowing the Glue instead of Curing them, then Topside process which is solder paste printing then compone
Electronics Forum | Wed Jun 18 10:07:02 EDT 2003 | caldon
There are a few directions to go from Here... 1) Outsource it to a CM, 2) Capital investment both have there issues. To Out source I would have processes in place to Inspect quality, resolve issues, Assure quaility, and Hope they can meet your deadli
Electronics Forum | Wed Jun 25 10:29:32 EDT 2003 | caldon
Hey Mike- We ran into the same thing when we purchased a Large CanadianManufacturers repair business. We were creative and first used an ESD bag cut open (Simulate the paper idea) then we used a 3M parts bin and would tip it on its corner to funnel t
Electronics Forum | Tue Jul 01 18:36:06 EDT 2003 | Matt Kehoe
I am trying to get opinions about a situation that we are discussing with a vendor/customer. While not a technical issue it has caused some confusion and I need some opinions to help settle the debate. We are a service bureau who receives stencil fi
Electronics Forum | Fri Jul 11 10:00:05 EDT 2003 | davef
Component manufacturers recommend limits on the power and period of ultrasonic cleaning. Examples are: * PRECAUTIONS AND GUIDELINES MULTILAYER CERAMIC CAPACITORS: (9) Ultrasonic cleaning time shall be ten minutes maximum. When the power of ultrasoni
Electronics Forum | Fri Jul 18 10:46:43 EDT 2003 | davef
If you are saying that you have discolored white tin at in-bound inspection, you have bad boards. The boards are fabricated incorrectly. Your fabricator is deficient. That is the GREAT thing about imm coatings. You can look at them and determine
