Electronics Forum | Fri Mar 29 11:02:04 EDT 2019 | robl
Not sure it's always a great route as the smaller ovens are going to struggle to get a perfect profile for a consistent result, especially on bigger boards with higher layer counts and mixed technology. You may want to take a quick look at a batch va
Electronics Forum | Mon Apr 09 14:05:25 EDT 2001 | slthomas
CAL's word of caution is right on. We tend to stay in the 220C-225C max. temp. on our profiles, and that's because the last heads up from engineering came on a part with a spec. of 230C max. temp. We just found out that one of our old SOIC's is spe
Electronics Forum | Mon Aug 13 16:07:08 EDT 2007 | dyoungquist
We run double sided surface mount boards through our Heller oven without any parts falling off the bottom side unless they are too big/heavy. The trick we use is to set the bottom side temperature in the final 3 heat zones 10C-20C lower than the top
Electronics Forum | Tue Sep 01 02:57:42 EDT 2009 | d0min0
davef As for the repair : - with hot air blower it is not possible (you can melt, but it will not wet) - with standard iron - no problem to repair (no additional material is needed) isd.jwendell yes, the profile is checked on those places (same si
Electronics Forum | Mon Apr 15 06:30:23 EDT 2019 | spoiltforchoice
Its not the max temperature that is the issue, its how much energy the oven is capable of transferring to the PCB inside the 4-6 minute window of a typical profile. In a conveyor oven this is achieved by having zones of different temperatures, but th
Electronics Forum | Fri Nov 08 14:19:59 EST 2019 | dwl
You can try putting titanium stiffeners on the PCB to prevent it from warping. How thick is your stencil? More paste would give you a wider window however too much and you risk bridging. You could try over printing the pad at the heel and toe to get
Electronics Forum | Fri Feb 10 12:21:44 EST 2006 | Cal Kolokoy
DaveF is correct in saying that TAL is not the best metric to use in reflow soldering. That is why paste manufacturers give such a wide range; typically 30 to 120 seconds. The peak temperature is more important, especially in the mixed Pb and Pb-F
Electronics Forum | Thu Sep 16 12:06:29 EDT 1999 | Scott S. Snider
| | | Hi, | | | | | | Can someone pls suggest to me the best reflow temperature setting | | | for a force air convection oven. The details is as follow. | | | 1) Heller 1700s | | | 2) 12 zone---6 top and 6 bot | | | 3) Solder paste --- Qualitek 691
Electronics Forum | Mon Aug 31 07:56:39 EDT 2009 | d0min0
Hello, since some days we are facing strange problem with SMT component reflow paste on one side of the component is reflowed correctly while the other side is 10%-70% non-reflowed (same component on 3 positions per module, alwyas the same land pad)
Electronics Forum | Wed Mar 17 22:04:05 EST 1999 | Dave F
| Looking for a company that makes a small batch reflow oven. Not a belt-style convection oven, but a cabinet style that can 125 c to 150 c. | | Thank you | Matt: The batch ovens we looked at were very difficult to program. They seemed to want t
.gif)
