Electronics Forum | Sun Mar 09 18:48:29 EST 2003 | Dean
Definitly evaluate the TD washer smt 324 / 318. I have two units and they have been fantastic from a maintenance point of view. Small, quiet and easy to maintain. I am in the middle of cleaning capability and ionic contamination testing as we spe
Electronics Forum | Tue Mar 11 09:26:36 EST 2003 | jseagle
Dave, Not sure if I understand the question. We do not process No-Clean in our facility at the current time. We are a completely Water-Soluble with a 12 year old Hollis Polyclean In-Line washer. I need to scrap the piece of ****. That's another
Electronics Forum | Fri Feb 28 09:16:49 EST 2003 | davef
Never heard of Bareco wax. Check with your press supplier. They'll have the dirt on this carnuba oil stuff. I do question replacing ENIG with HASL, no other changes. HASL is going to fill that hole alot more than ENIG. Certainly it will displace
Electronics Forum | Fri Feb 28 11:08:56 EST 2003 | pauld
I had the same concern. The connector pins are gold also. I am waiting for a response from AMP to supply some of this wonder wax. I can inspect the HASL fabs for proper hole diameter, but I do not have a warm feeling I should be getting involved with
Electronics Forum | Fri Feb 28 11:45:42 EST 2003 | MA/NY DDave
Hi http://barecowax.com/About%20Bareco.htm You will notice they have a lot of products. After you get from AMP the actual Bareco lubrication product they are recommending for their product application make sure you know what cleaning method remove
Electronics Forum | Sat Mar 01 16:36:58 EST 2003 | MA/NY DDave
Hi Based on what I read, I think you have a small shop and may just have to make up your own system. You could hire an Industrial Engineer or Production Control Specialist to find or set up the best cost effective system for you. Poke around on thi
Electronics Forum | Sun Mar 16 20:54:04 EST 2003 | MA/NY DDave
Hi Well you got lucky with this note series. See the abbreviations Steve gave in the note above yours. Then go to my note up earlier and click on the web site I listed. Then go to the Buyers guide and you will see two of the choices are "Steve's a
Electronics Forum | Wed Mar 26 22:32:02 EST 2003 | dlkearns1
Have you seen or heard of Fouth Shift MRP or Avante MRP? I've used both of these. In my opinion, not good for a small company, and can be expensive, REAL big $$$ to implement. 4thshift and Avante MRP systems are NOT a do it yourself kinda package. S
Electronics Forum | Sat Mar 01 17:46:30 EST 2003 | MA/NY DDave
Hi I keep getting these flyers and wonder if anyone has used this particular type tooling from Transition Automation http://www.board-lok.com for DEK or MPM printers. I searched the archives and didn't find anything via "board-lok" or "board lok"
Electronics Forum | Mon Mar 03 10:19:57 EST 2003 | jseagle
We just got Red-E-Set from Production Solutions for our DEK ELA printer. It is a similar concept, it's mechanical instead of hydralic or pnumatic. The print results are very good and the operators love how easy they are to setup. I am planning on
