Electronics Forum | Thu Jul 28 19:08:05 EDT 2011 | garym4569
Right now we are mainly using it in bypass mode until we can program our new inspection recipes. We also tried setting a quick inspection program just to see if bypass mode was not working correctly. Still will not handle pcb transfer correctly. I
Electronics Forum | Thu Jul 28 21:32:06 EDT 2011 | rway
We are using 2.7.7. I have two M1 systems, but the sw is the same. I am not at work at the moment, but I will look tomorrow and let you know. On a side note, the conveyor will run continuously when in bypass mode. It does sound like you have a tra
Electronics Forum | Wed Aug 03 10:09:27 EDT 2011 | geb
Our Samsung CP45FV Neo is out of warranty, but due for its annual calibration/ service, however we are wondering whether it is really needed. The line only runs for 8 hours a day 5 days per week (including setup), so not heavy usage. The manual does
Electronics Forum | Fri Aug 12 09:07:23 EDT 2011 | rway
The rails are being sourced by the regulators. Rails, bus, you can use them interchangeably. As far as what voltage? I have no idea other than my assumptions listed above, but more than likely you will have +/-12V and 5V. Depending on the age of t
Electronics Forum | Thu Aug 25 21:26:27 EDT 2011 | leadthree
Solderability could be an issue. We usually buy the IC and stock it for up to 9 month. This time the ICs was from a broker and the datecode was not the latest. This said, we use already a solder paste that contains watersoluble flux, which is suppos
Electronics Forum | Fri Feb 17 14:11:32 EST 2012 | tkotwal
I'm also looking for tips for SMT hand soldering with Sn05Pb93.5Ag1.5. Our technician is quite good with standard SMT hand soldering, but hasn't worked with HMP solder. Some specific questions: - If the iron tip is hot enough (consistently), can we
Electronics Forum | Tue Aug 30 22:39:29 EDT 2011 | comatose
I'm looking at used reflow ovens. I'm homing in on Vitronics. We're pretty self-sufficient in terms of keeping machines going, but does anyone have experience with parts and documentation support for Vitronics? Is there a fee for getting into the sys
Electronics Forum | Thu Sep 08 18:01:22 EDT 2011 | comatose
We had a camera die on one of our GSMs. I got a new camera, and it is working, but I need to either find a cal kit to rent for a day, or else if someone knows a reasonably accurate procedure to calibrate the new camera using the other upward looking
Electronics Forum | Wed Sep 21 15:13:08 EDT 2011 | gregcr
Where are you located? Along the same lines, I have a trick I used a couple times when replacing a camera. It is often not the image sensor that goes bad, but the camera electronics behind the sensor. I have had luck taking the camera apart but le
Electronics Forum | Fri Sep 09 18:19:25 EDT 2011 | cusackmusic
First of all, if you are going to tell me to throw my crappy equipment away, and buy a better oven because 3 zones isn't enough for lead free soldering, please find another thread to troll in. We have been using a Hotflow 3 for several years for lea