Electronics Forum | Wed Jun 09 12:28:29 EDT 2004 | abarbe
Hi I'm looking for a user manual(copy) for camalot 1414. Software version 9.4(made in 1992). We will pay for the copy. Thank you
Electronics Forum | Thu Jun 10 09:18:14 EDT 2004 | Dennis
Please call (508) 520-6999 (ext 6442)(Dave Redfearn). Scott is a service contact for Camalot products and can help you secure a copy of this manual.
Electronics Forum | Wed Jun 09 15:09:29 EDT 2004 | dwoodrow
Does anyone out there use anything besides alcohol in their automatic claw/finger cleaners in their wave solder machines? We are nearing our VOC limit and are looking into other chemicals (VOC-free) for cleaning. Thanks David
Electronics Forum | Wed Jun 09 15:53:09 EDT 2004 | Ordie.
You might want to try Zestron. They make a lot of different cleaners. We use Zestron SD 300 if we clean a stencil by hand. It works great, a lot better than alcohol. Go to http://www.zestron.com. Hope this helps.
Electronics Forum | Mon Jun 14 04:44:15 EDT 2004 | Sam
1. Don't use a PCB for calibration because the tactile sensor have to free to touch the bottom side of stencil. 2. The wiper is option, the function can be disable in the setup menu.
Electronics Forum | Fri Jun 11 12:46:19 EDT 2004 | Rob
I can't imagine a board to be 2" thick. Am I misunderstanding here? The thickest board I work with is 0.09" thick. That translates to 2.28mm. Did someone say that there is a standard to follow with regards to components near board edges or V-grooves?
Electronics Forum | Fri Jun 11 09:41:45 EDT 2004 | cyber_wolf
If you have components wedged in tape pockets, you need to contact your component supplier and tell them that you need new parts taped properly. We see this happen every now and then.
Electronics Forum | Fri Jun 11 06:06:41 EDT 2004 | davef
Have your designer place the via on the edge of the pad, centered and cover it with soldermask. If this is a leadless capacitor or resistor-style component, the corresponding pads will need to partially covered with solder mask to match the via in p
Electronics Forum | Fri Jun 11 09:55:18 EDT 2004 | karic
Looking for Cyberoptics AOI users. I would like info regarding how your systems are working for you. (Feel free to contact me offline at kchristianson@altronmfg.com ) Thanks Kari
Electronics Forum | Sat Jun 12 04:06:33 EDT 2004 | Steve
Hi, Anybody has the experience or information of mounting the SMD 0402 on solder side of PCB by adhesive (apply by stencil printing) and then wave solder the 0402? Best regards.